blob: 7e8d6f8002d62bc941a4b3ab4176b88d5eb13292 [file] [log] [blame]
#ifndef _NATSEMI_H
#define _NATSEMI_H
/** @file
*
* National Semiconductor "MacPhyter" network card driver
*
*/
FILE_LICENCE ( GPL2_OR_LATER );
#include <stdint.h>
#include <ipxe/spi.h>
#include <ipxe/spi_bit.h>
/** BAR size */
#define NATSEMI_BAR_SIZE 0x100
/** A 32-bit packet descriptor */
struct natsemi_descriptor_32 {
/** Link to next descriptor */
uint32_t link;
/** Command / status */
uint32_t cmdsts;
/** Buffer pointer */
uint32_t bufptr;
} __attribute__ (( packed ));
/** A 64-bit packet descriptor */
struct natsemi_descriptor_64 {
/** Link to next descriptor */
uint64_t link;
/** Buffer pointer */
uint64_t bufptr;
/** Command / status */
uint32_t cmdsts;
/** Extended status */
uint32_t extsts;
} __attribute__ (( packed ));
/** A packet descriptor
*
* The 32-bit and 64-bit variants are overlaid such that "cmdsts" can
* be accessed as a common field, and the overall size is a power of
* two (to allow the descriptor ring length to be used as an
* alignment).
*/
union natsemi_descriptor {
/** Common fields */
struct {
/** Reserved */
uint8_t reserved_a[16];
/** Command / status */
uint32_t cmdsts;
/** Reserved */
uint8_t reserved_b[12];
} __attribute__ (( packed )) common;
/** 64-bit descriptor */
struct natsemi_descriptor_64 d64;
/** 32-bit descriptor */
struct {
/** Reserved */
uint8_t reserved[12];
/** Descriptor */
struct natsemi_descriptor_32 d32;
} __attribute__ (( packed )) d32pad;
};
/** Descriptor buffer size mask */
#define NATSEMI_DESC_SIZE_MASK 0xfff
/** Packet descriptor flags */
enum natsemi_descriptor_flags {
/** Descriptor is owned by NIC */
NATSEMI_DESC_OWN = 0x80000000UL,
/** Request descriptor interrupt */
NATSEMI_DESC_INTR = 0x20000000UL,
/** Packet OK */
NATSEMI_DESC_OK = 0x08000000UL,
};
/** Command Register */
#define NATSEMI_CR 0x0000
#define NATSEMI_CR_RST 0x00000100UL /**< Reset */
#define NATSEMI_CR_RXR 0x00000020UL /**< Receiver reset */
#define NATSEMI_CR_TXR 0x00000010UL /**< Transmit reset */
#define NATSEMI_CR_RXE 0x00000004UL /**< Receiver enable */
#define NATSEMI_CR_TXE 0x00000001UL /**< Transmit enable */
/** Maximum time to wait for a reset, in milliseconds */
#define NATSEMI_RESET_MAX_WAIT_MS 100
/** Configuration and Media Status Register */
#define NATSEMI_CFG 0x0004
#define NATSEMI_CFG_LNKSTS 0x80000000UL /**< Link status */
#define NATSEMI_CFG_SPDSTS1 0x40000000UL /**< Speed status bit 1 */
#define NATSEMI_CFG_MODE_1000 0x00400000UL /**< 1000 Mb/s mode control */
#define NATSEMI_CFG_PCI64_DET 0x00002000UL /**< PCI 64-bit bus detected */
#define NATSEMI_CFG_DATA64_EN 0x00001000UL /**< 64-bit data enable */
#define NATSEMI_CFG_M64ADDR 0x00000800UL /**< 64-bit address enable */
#define NATSEMI_CFG_EXTSTS_EN 0x00000100UL /**< Extended status enable */
/** EEPROM Access Register */
#define NATSEMI_MEAR 0x0008
#define NATSEMI_MEAR_EESEL 0x00000008UL /**< EEPROM chip select */
#define NATSEMI_MEAR_EECLK 0x00000004UL /**< EEPROM serial clock */
#define NATSEMI_MEAR_EEDO 0x00000002UL /**< EEPROM data out */
#define NATSEMI_MEAR_EEDI 0x00000001UL /**< EEPROM data in */
/** Size of EEPROM (in bytes) */
#define NATSEMI_EEPROM_SIZE 32
/** Word offset of MAC address within sane EEPROM layout */
#define NATSEMI_EEPROM_MAC_SANE 0x0a
/** Word offset of MAC address within insane EEPROM layout */
#define NATSEMI_EEPROM_MAC_INSANE 0x06
/** PCI Test Control Register */
#define NATSEMI_PTSCR 0x000c
#define NATSEMI_PTSCR_EELOAD_EN 0x00000004UL /**< Enable EEPROM load */
/** Maximum time to wait for a configuration reload, in milliseconds */
#define NATSEMI_EELOAD_MAX_WAIT_MS 100
/** Interrupt Status Register */
#define NATSEMI_ISR 0x0010
#define NATSEMI_IRQ_TXDESC 0x00000080UL /**< TX descriptor */
#define NATSEMI_IRQ_RXDESC 0x00000002UL /**< RX descriptor */
/** Interrupt Mask Register */
#define NATSEMI_IMR 0x0014
/** Interrupt Enable Register */
#define NATSEMI_IER 0x0018
#define NATSEMI_IER_IE 0x00000001UL /**< Interrupt enable */
/** Transmit Descriptor Pointer */
#define NATSEMI_TXDP 0x0020
/** Transmit Descriptor Pointer High Dword (64-bit) */
#define NATSEMI_TXDP_HI_64 0x0024
/** Number of transmit descriptors */
#define NATSEMI_NUM_TX_DESC 4
/** Transmit configuration register (32-bit) */
#define NATSEMI_TXCFG_32 0x24
/** Transmit configuration register (64-bit) */
#define NATSEMI_TXCFG_64 0x28
#define NATSEMI_TXCFG_CSI 0x80000000UL /**< Carrier sense ignore */
#define NATSEMI_TXCFG_HBI 0x40000000UL /**< Heartbeat ignore */
#define NATSEMI_TXCFG_ATP 0x10000000UL /**< Automatic padding */
#define NATSEMI_TXCFG_ECRETRY 0x00800000UL /**< Excess collision retry */
#define NATSEMI_TXCFG_MXDMA(x) ( (x) << 20 ) /**< Max DMA burst size */
#define NATSEMI_TXCFG_FLTH(x) ( (x) << 8 ) /**< Fill threshold */
#define NATSEMI_TXCFG_DRTH(x) ( (x) << 0 ) /**< Drain threshold */
/** Max DMA burst size (encoded value)
*
* This represents 256-byte bursts on 83815 controllers and 512-byte
* bursts on 83820 controllers.
*/
#define NATSEMI_TXCFG_MXDMA_DEFAULT NATSEMI_TXCFG_MXDMA ( 0x7 )
/** Fill threshold (in units of 32 bytes)
*
* Must be at least as large as the max DMA burst size, so use a value
* of 512 bytes.
*/
#define NATSEMI_TXCFG_FLTH_DEFAULT NATSEMI_TXCFG_FLTH ( 512 / 32 )
/** Drain threshold (in units of 32 bytes)
*
* Start transmission once we receive a conservative 1024 bytes, to
* avoid FIFO underrun errors. (83815 does not allow us to specify a
* value of 0 for "wait until whole packet is present".)
*
* Fill threshold plus drain threshold must be less than the transmit
* FIFO size, which is 2kB on 83815 and 8kB on 83820.
*/
#define NATSEMI_TXCFG_DRTH_DEFAULT NATSEMI_TXCFG_DRTH ( 1024 / 32 )
/** Receive Descriptor Pointer */
#define NATSEMI_RXDP 0x0030
/** Receive Descriptor Pointer High Dword (64-bit) */
#define NATSEMI_RXDP_HI_64 0x0034
/** Number of receive descriptors */
#define NATSEMI_NUM_RX_DESC 4
/** Receive buffer length */
#define NATSEMI_RX_MAX_LEN ( ETH_FRAME_LEN + 4 /* VLAN */ + 4 /* CRC */ )
/** Receive configuration register (32-bit) */
#define NATSEMI_RXCFG_32 0x34
/** Receive configuration register (64-bit) */
#define NATSEMI_RXCFG_64 0x38
#define NATSEMI_RXCFG_ARP 0x40000000UL /**< Accept runt packets */
#define NATSEMI_RXCFG_ATX 0x10000000UL /**< Accept transmit packets */
#define NATSEMI_RXCFG_ALP 0x08000000UL /**< Accept long packets */
#define NATSEMI_RXCFG_MXDMA(x) ( (x) << 20 ) /**< Max DMA burst size */
#define NATSEMI_RXCFG_DRTH(x) ( (x) << 1 ) /**< Drain threshold */
/** Max DMA burst size (encoded value)
*
* This represents 256-byte bursts on 83815 controllers and 512-byte
* bursts on 83820 controllers.
*/
#define NATSEMI_RXCFG_MXDMA_DEFAULT NATSEMI_RXCFG_MXDMA ( 0x7 )
/** Drain threshold (in units of 8 bytes)
*
* Start draining after 64 bytes.
*
* Must be large enough to allow packet's accept/reject status to be
* determined before draining begins.
*/
#define NATSEMI_RXCFG_DRTH_DEFAULT NATSEMI_RXCFG_DRTH ( 64 / 8 )
/** Receive Filter/Match Control Register */
#define NATSEMI_RFCR 0x0048
#define NATSEMI_RFCR_RFEN 0x80000000UL /**< RX filter enable */
#define NATSEMI_RFCR_AAB 0x40000000UL /**< Accept all broadcast */
#define NATSEMI_RFCR_AAM 0x20000000UL /**< Accept all multicast */
#define NATSEMI_RFCR_AAU 0x10000000UL /**< Accept all unicast */
#define NATSEMI_RFCR_RFADDR( addr ) ( (addr) << 0 ) /**< Extended address */
#define NATSEMI_RFCR_RFADDR_MASK NATSEMI_RFCR_RFADDR ( 0x3ff )
/** Perfect match filter address base */
#define NATSEMI_RFADDR_PMATCH_BASE 0x000
/** Receive Filter/Match Data Register */
#define NATSEMI_RFDR 0x004c
#define NATSEMI_RFDR_BMASK 0x00030000UL /**< Byte mask */
#define NATSEMI_RFDR_DATA( value ) ( (value) & 0xffff ) /**< Filter data */
/** National Semiconductor network card flags */
enum natsemi_nic_flags {
/** EEPROM is little-endian */
NATSEMI_EEPROM_LITTLE_ENDIAN = 0x0001,
/** EEPROM layout is insane */
NATSEMI_EEPROM_INSANE = 0x0002,
/** Card supports 64-bit operation */
NATSEMI_64BIT = 0x0004,
/** Card supports 1000Mbps link */
NATSEMI_1000 = 0x0008,
};
/** A National Semiconductor descriptor ring */
struct natsemi_ring {
/** Descriptors */
union natsemi_descriptor *desc;
/** Producer index */
unsigned int prod;
/** Consumer index */
unsigned int cons;
/** Number of descriptors */
unsigned int count;
/** Descriptor start address register */
unsigned int reg;
};
/**
* Initialise descriptor ring
*
* @v ring Descriptor ring
* @v count Number of descriptors
* @v reg Descriptor start address register
*/
static inline __attribute__ (( always_inline)) void
natsemi_init_ring ( struct natsemi_ring *ring, unsigned int count,
unsigned int reg ) {
ring->count = count;
ring->reg = reg;
}
/** A National Semiconductor network card */
struct natsemi_nic {
/** Flags */
unsigned int flags;
/** Registers */
void *regs;
/** SPI bit-bashing interface */
struct spi_bit_basher spibit;
/** EEPROM */
struct spi_device eeprom;
/** Transmit descriptor ring */
struct natsemi_ring tx;
/** Receive descriptor ring */
struct natsemi_ring rx;
/** Receive I/O buffers */
struct io_buffer *rx_iobuf[NATSEMI_NUM_RX_DESC];
/** Link status (cache) */
uint32_t cfg;
};
/**
* Check if card can access physical address
*
* @v natsemi National Semiconductor device
* @v address Physical address
* @v address_ok Card can access physical address
*/
static inline __attribute__ (( always_inline )) int
natsemi_address_ok ( struct natsemi_nic *natsemi, physaddr_t address ) {
/* In a 32-bit build, all addresses can be accessed */
if ( sizeof ( physaddr_t ) <= sizeof ( uint32_t ) )
return 1;
/* A 64-bit card can access all addresses */
if ( natsemi->flags & NATSEMI_64BIT )
return 1;
/* A 32-bit card can access all addresses below 4GB */
if ( ( address & ~0xffffffffULL ) == 0 )
return 1;
return 0;
}
#endif /* _NATSEMI_H */