| config FIRMWARE |
| bool "Enable Firmware driver support" |
| |
| config SPL_FIRMWARE |
| bool "Enable Firmware driver support in SPL" |
| depends on FIRMWARE && SPL |
| |
| config SPL_ARM_PSCI_FW |
| bool |
| select SPL_FIRMWARE |
| |
| config ARM_PSCI_FW |
| bool |
| select FIRMWARE |
| |
| config TI_SCI_PROTOCOL |
| tristate "TI System Control Interface (TISCI) Message Protocol" |
| depends on K3_SEC_PROXY |
| select FIRMWARE |
| select SPL_FIRMWARE if SPL |
| help |
| TI System Control Interface (TISCI) Message Protocol is used to manage |
| compute systems such as ARM, DSP etc with the system controller in |
| complex System on Chip (SoC) such as those found on certain K3 |
| generation SoC from TI. |
| |
| This protocol library is used by client drivers to use the features |
| provided by the system controller. |
| |
| config ZYNQMP_FIRMWARE |
| bool "ZynqMP Firmware interface" |
| select FIRMWARE |
| help |
| Firmware interface driver is used by different |
| drivers to communicate with the firmware for |
| various platform management services. |
| Say yes to enable ZynqMP firmware interface driver. |
| If in doubt, say N. |
| |
| config ARM_SMCCC_FEATURES |
| bool "Arm SMCCC features discovery" |
| depends on ARM_PSCI_FW |
| help |
| Discover Arm SMCCC features for which a U-Boot driver is defined. When enabled, |
| the PSCI driver is always probed and binds dirvers registered to the Arm SMCCC |
| services if any and reported as supported by the SMCCC firmware. |
| |
| source "drivers/firmware/arm-ffa/Kconfig" |
| source "drivers/firmware/scmi/Kconfig" |
