blob: c6ff387351c4b9f03edf909cbeb6b8b614661db3 [file] [log] [blame]
if TARGET_APALIS_IMX6
config SYS_BOARD
default "apalis_imx6"
config SYS_CONFIG_NAME
default "apalis_imx6"
config SYS_CPU
default "armv7"
config SYS_SOC
default "mx6"
config SYS_VENDOR
default "toradex"
config TDX_CFG_BLOCK
default y
config TDX_HAVE_MMC
default y
config TDX_CFG_BLOCK_DEV
default "0"
config TDX_CFG_BLOCK_PART
default "1"
# Toradex config block in eMMC, at the end of 1st "boot sector"
config TDX_CFG_BLOCK_OFFSET
default "-512"
config TDX_CMD_IMX_MFGR
bool "Enable factory testing commands for Toradex iMX 6 modules"
help
This adds the commands
pf0100_otp_prog - Program the OTP fuses on the PMIC PF0100
If executed on already fused modules it doesn't change any fuse setting.
default y
config TDX_APALIS_IMX6_V1_0
bool "Apalis iMX6 V1.0 HW"
help
Apalis iMX6 V1.0 HW has a different pinout for the UART.
The UARTs must be used in DCE mode, RTS/CTS are swapped and
thus unusable on standard carrier boards.
This option configures DCE mode unconditionally. Whithout this
option the config block stating V1.0 HW selects DCE mode,
otherwise the UARTs are configuered in DTE mode.
source "board/toradex/common/Kconfig"
endif