blob: 3e322c4d7191a61c8d58b5d5d8c39b58f96b71e2 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
/*
* Copyright (C) 2019, STMicroelectronics - All Rights Reserved
*/
#define LOG_CATEGORY UCLASS_REMOTEPROC
#include <common.h>
#include <dm.h>
#include <errno.h>
#include <fdtdec.h>
#include <log.h>
#include <remoteproc.h>
#include <reset.h>
#include <asm/io.h>
#include <dm/device_compat.h>
#include <linux/err.h>
#include <linux/printk.h>
/**
* struct stm32_copro_privdata - power processor private data
* @reset_ctl: reset controller handle
* @hold_boot: hold boot controller handle
* @rsc_table_addr: resource table address
*/
struct stm32_copro_privdata {
struct reset_ctl reset_ctl;
struct reset_ctl hold_boot;
ulong rsc_table_addr;
};
/**
* stm32_copro_probe() - Basic probe
* @dev: corresponding STM32 remote processor device
* Return: 0 if all went ok, else corresponding -ve error
*/
static int stm32_copro_probe(struct udevice *dev)
{
struct stm32_copro_privdata *priv;
int ret;
priv = dev_get_priv(dev);
ret = reset_get_by_name(dev, "mcu_rst", &priv->reset_ctl);
if (ret) {
dev_err(dev, "failed to get reset (%d)\n", ret);
return ret;
}
ret = reset_get_by_name(dev, "hold_boot", &priv->hold_boot);
if (ret) {
dev_err(dev, "failed to get hold boot (%d)\n", ret);
return ret;
}
dev_dbg(dev, "probed\n");
return 0;
}
/**
* stm32_copro_device_to_virt() - Convert device address to virtual address
* @dev: corresponding STM32 remote processor device
* @da: device address
* @size: Size of the memory region @da is pointing to
* Return: converted virtual address
*/
static void *stm32_copro_device_to_virt(struct udevice *dev, ulong da,
ulong size)
{
fdt32_t in_addr = cpu_to_be32(da), end_addr;
u64 paddr;
paddr = dev_translate_dma_address(dev, &in_addr);
if (paddr == OF_BAD_ADDR) {
dev_err(dev, "Unable to convert address %ld\n", da);
return NULL;
}
end_addr = cpu_to_be32(da + size - 1);
if (dev_translate_dma_address(dev, &end_addr) == OF_BAD_ADDR) {
dev_err(dev, "Unable to convert address %ld\n", da + size - 1);
return NULL;
}
return phys_to_virt(paddr);
}
/**
* stm32_copro_load() - Loadup the STM32 remote processor
* @dev: corresponding STM32 remote processor device
* @addr: Address in memory where image is stored
* @size: Size in bytes of the image
* Return: 0 if all went ok, else corresponding -ve error
*/
static int stm32_copro_load(struct udevice *dev, ulong addr, ulong size)
{
struct stm32_copro_privdata *priv;
ulong rsc_table_size;
int ret;
priv = dev_get_priv(dev);
ret = reset_assert(&priv->hold_boot);
if (ret) {
dev_err(dev, "Unable to assert hold boot (ret=%d)\n", ret);
return ret;
}
ret = reset_assert(&priv->reset_ctl);
if (ret) {
dev_err(dev, "Unable to assert reset line (ret=%d)\n", ret);
return ret;
}
if (rproc_elf32_load_rsc_table(dev, addr, size, &priv->rsc_table_addr,
&rsc_table_size)) {
priv->rsc_table_addr = 0;
dev_warn(dev, "No valid resource table for this firmware\n");
}
return rproc_elf32_load_image(dev, addr, size);
}
/**
* stm32_copro_start() - Start the STM32 remote processor
* @dev: corresponding STM32 remote processor device
* Return: 0 if all went ok, else corresponding -ve error
*/
static int stm32_copro_start(struct udevice *dev)
{
struct stm32_copro_privdata *priv;
int ret;
priv = dev_get_priv(dev);
ret = reset_deassert(&priv->hold_boot);
if (ret) {
dev_err(dev, "Unable to deassert hold boot (ret=%d)\n", ret);
return ret;
}
/*
* Once copro running, reset hold boot flag to avoid copro
* rebooting autonomously (error should never occur)
*/
ret = reset_assert(&priv->hold_boot);
if (ret)
dev_err(dev, "Unable to assert hold boot (ret=%d)\n", ret);
/* indicates that copro is running */
writel(TAMP_COPRO_STATE_CRUN, TAMP_COPRO_STATE);
/* Store rsc_address in bkp register */
writel(priv->rsc_table_addr, TAMP_COPRO_RSC_TBL_ADDRESS);
return 0;
}
/**
* stm32_copro_reset() - Reset the STM32 remote processor
* @dev: corresponding STM32 remote processor device
* Return: 0 if all went ok, else corresponding -ve error
*/
static int stm32_copro_reset(struct udevice *dev)
{
struct stm32_copro_privdata *priv;
int ret;
priv = dev_get_priv(dev);
ret = reset_assert(&priv->hold_boot);
if (ret) {
dev_err(dev, "Unable to assert hold boot (ret=%d)\n", ret);
return ret;
}
ret = reset_assert(&priv->reset_ctl);
if (ret) {
dev_err(dev, "Unable to assert reset line (ret=%d)\n", ret);
return ret;
}
writel(TAMP_COPRO_STATE_OFF, TAMP_COPRO_STATE);
return 0;
}
/**
* stm32_copro_stop() - Stop the STM32 remote processor
* @dev: corresponding STM32 remote processor device
* Return: 0 if all went ok, else corresponding -ve error
*/
static int stm32_copro_stop(struct udevice *dev)
{
return stm32_copro_reset(dev);
}
/**
* stm32_copro_is_running() - Is the STM32 remote processor running
* @dev: corresponding STM32 remote processor device
* Return: 0 if the remote processor is running, 1 otherwise
*/
static int stm32_copro_is_running(struct udevice *dev)
{
return (readl(TAMP_COPRO_STATE) == TAMP_COPRO_STATE_OFF);
}
static const struct dm_rproc_ops stm32_copro_ops = {
.load = stm32_copro_load,
.start = stm32_copro_start,
.stop = stm32_copro_stop,
.reset = stm32_copro_reset,
.is_running = stm32_copro_is_running,
.device_to_virt = stm32_copro_device_to_virt,
};
static const struct udevice_id stm32_copro_ids[] = {
{.compatible = "st,stm32mp1-m4"},
{}
};
U_BOOT_DRIVER(stm32_copro) = {
.name = "stm32_m4_proc",
.of_match = stm32_copro_ids,
.id = UCLASS_REMOTEPROC,
.ops = &stm32_copro_ops,
.probe = stm32_copro_probe,
.priv_auto = sizeof(struct stm32_copro_privdata),
};