| CONFIG_ARM=y |
| CONFIG_SYS_L2CACHE_OFF=y |
| CONFIG_ARCH_TEGRA=y |
| CONFIG_TEXT_BASE=0x80110000 |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_SF_DEFAULT_SPEED=24000000 |
| CONFIG_ENV_SIZE=0x2000 |
| CONFIG_ENV_OFFSET=0xFFFFE000 |
| CONFIG_DEFAULT_DEVICE_TREE="tegra30-tec-ng" |
| CONFIG_SPL_TEXT_BASE=0x80108000 |
| CONFIG_SPL_STACK=0x800ffffc |
| CONFIG_TEGRA30=y |
| CONFIG_TARGET_TEC_NG=y |
| CONFIG_TEGRA_ENABLE_UARTD=y |
| CONFIG_SYS_LOAD_ADDR=0x81000000 |
| CONFIG_FIT=y |
| CONFIG_OF_SYSTEM_SETUP=y |
| CONFIG_SYS_PBSIZE=2084 |
| CONFIG_CONSOLE_MUX=y |
| CONFIG_SYS_STDIO_DEREGISTER=y |
| CONFIG_SPL_FOOTPRINT_LIMIT=y |
| CONFIG_SPL_MAX_FOOTPRINT=0x8000 |
| # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set |
| CONFIG_SPL_SYS_MALLOC=y |
| CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y |
| CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x80090000 |
| CONFIG_SPL_SYS_MALLOC_SIZE=0x10000 |
| CONFIG_SYS_PROMPT="Tegra30 (TEC-NG) # " |
| # CONFIG_CMD_IMI is not set |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_SPI=y |
| CONFIG_CMD_USB=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_EXT4_WRITE=y |
| # CONFIG_SPL_DOS_PARTITION is not set |
| # CONFIG_SPL_EFI_PARTITION is not set |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_SYS_MMC_ENV_PART=2 |
| CONFIG_SYS_I2C_TEGRA=y |
| CONFIG_SPI_FLASH_WINBOND=y |
| CONFIG_SYS_NS16550=y |
| CONFIG_TEGRA20_SLINK=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_USB_EHCI_TEGRA=y |
| CONFIG_USB_HOST_ETHER=y |
| CONFIG_USB_ETHER_SMSC95XX=y |
