| /* SPDX-License-Identifier: GPL-2.0+ */ |
| /* |
| * Copyright 2019-2021 NXP |
| */ |
| |
| #ifndef __L1028A_COMMON_H |
| #define __L1028A_COMMON_H |
| |
| #include <asm/arch/stream_id_lsch3.h> |
| #include <asm/arch/config.h> |
| #include <asm/arch/soc.h> |
| |
| /* Link Definitions */ |
| |
| #define CFG_SYS_DDR_SDRAM_BASE 0x80000000UL |
| #define CFG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 |
| #define CFG_SYS_SDRAM_BASE CFG_SYS_DDR_SDRAM_BASE |
| #define CFG_SYS_DDR_BLOCK2_BASE 0x2080000000ULL |
| |
| /* |
| * SMP Definitinos |
| */ |
| #define CPU_RELEASE_ADDR secondary_boot_addr |
| |
| /* GPIO */ |
| |
| /* I2C */ |
| |
| /* Serial Port */ |
| #define CFG_SYS_NS16550_CLK (get_bus_freq(0) / 2) |
| |
| /* Miscellaneous configurable options */ |
| |
| /* Physical Memory Map */ |
| |
| #define HWCONFIG_BUFFER_SIZE 128 |
| |
| #define BOOT_TARGET_DEVICES(func) \ |
| func(MMC, mmc, 0) \ |
| func(MMC, mmc, 1) \ |
| func(USB, usb, 0) \ |
| func(DHCP, dhcp, na) |
| #include <config_distro_bootcmd.h> |
| |
| #define XSPI_NOR_BOOTCOMMAND \ |
| "run xspi_hdploadcmd; run distro_bootcmd; run xspi_bootcmd; " \ |
| "env exists secureboot && esbc_halt;;" |
| #define SD_BOOTCOMMAND \ |
| "run sd_hdploadcmd; run distro_bootcmd;run sd_bootcmd; " \ |
| "env exists secureboot && esbc_halt;" |
| #define SD2_BOOTCOMMAND \ |
| "run emmc_hdploadcmd; run distro_bootcmd;run emmc_bootcmd; " \ |
| "env exists secureboot && esbc_halt;" |
| |
| #define OCRAM_NONSECURE_SIZE 0x00010000 |
| #define CFG_SYS_FSL_QSPI_BASE 0x20000000 |
| |
| /* I2C bus multiplexer */ |
| #define I2C_MUX_PCA_ADDR_PRI 0x77 /* Primary Mux*/ |
| #define I2C_MUX_CH_DEFAULT 0x8 |
| |
| /* DisplayPort */ |
| #define DP_PWD_EN_DEFAULT_MASK 0x8 |
| |
| #ifdef CONFIG_NXP_ESBC |
| #include <asm/fsl_secure_boot.h> |
| #endif |
| |
| #endif /* __L1028A_COMMON_H */ |
