blob: 315b6dc5429573001c1eb48e9f7b7e20bef414c3 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2016 Stefan Roese <sr@denx.de>
*/
#include <common.h>
#include <i2c.h>
#include <init.h>
#include <winbond_w83627.h>
#include <asm/gpio.h>
#include <asm/ibmpc.h>
#include <asm/pnp_def.h>
int board_early_init_f(void)
{
#ifndef CONFIG_INTERNAL_UART
/*
* The FSP enables the BayTrail internal legacy UART (again).
* Disable it again, so that the Winbond one can be used.
*/
setup_internal_uart(0);
/* Enable the legacy UART in the Winbond W83627 Super IO chip */
winbond_enable_serial(PNP_DEV(WINBOND_IO_PORT, W83627DHG_SP1),
UART0_BASE, UART0_IRQ);
#endif
return 0;
}
int board_late_init(void)
{
struct udevice *dev;
u8 buf[8];
int ret;
/* Configure SMSC USB2513 USB Hub: 7bit address 0x2c */
ret = i2c_get_chip_for_busnum(0, 0x2c, 1, &dev);
if (ret) {
printf("Cannot find USB2513: %d\n", ret);
return 0;
}
/*
* The first access to the USB Hub fails sometimes, so lets read
* a dummy byte to be sure here
*/
dm_i2c_read(dev, 0x00, buf, 1);
/*
* The SMSC hub is not visible on the I2C bus after the first
* configuration at power-up. The following code deliberately
* does not report upon failure of these I2C write calls.
*/
buf[0] = 0x93;
dm_i2c_write(dev, 0x06, buf, 1);
buf[0] = 0xaa;
dm_i2c_write(dev, 0xf8, buf, 1);
buf[0] = 0x0f;
dm_i2c_write(dev, 0xfa, buf, 1);
buf[0] = 0x01;
dm_i2c_write(dev, 0xff, buf, 1);
return 0;
}