blob: ab532c5a420eb91ef2204c8154f1a3b10c42df9e [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2015-2016 Freescale Semiconductor, Inc.
* Copyright 2017 NXP
*/
#include <common.h>
#include <dm.h>
#include <log.h>
#include <malloc.h>
#include <dm/platform_data/pfe_dm_eth.h>
#include <net.h>
#include <linux/delay.h>
#include <net/pfe_eth/pfe_eth.h>
#include <net/pfe_eth/pfe_mdio.h>
struct gemac_s gem_info[] = {
/* PORT_0 configuration */
{
/* GEMAC config */
.gemac_speed = PFE_MAC_SPEED_1000M,
.gemac_duplex = DUPLEX_FULL,
/* phy iface */
.phy_address = CONFIG_PFE_EMAC1_PHY_ADDR,
.phy_mode = PHY_INTERFACE_MODE_SGMII,
},
/* PORT_1 configuration */
{
/* GEMAC config */
.gemac_speed = PFE_MAC_SPEED_1000M,
.gemac_duplex = DUPLEX_FULL,
/* phy iface */
.phy_address = CONFIG_PFE_EMAC2_PHY_ADDR,
.phy_mode = PHY_INTERFACE_MODE_RGMII_ID,
},
};
static inline void pfe_gemac_enable(void *gemac_base)
{
writel(readl(gemac_base + EMAC_ECNTRL_REG) |
EMAC_ECNTRL_ETHER_EN, gemac_base + EMAC_ECNTRL_REG);
}
static inline void pfe_gemac_disable(void *gemac_base)
{
writel(readl(gemac_base + EMAC_ECNTRL_REG) &
~EMAC_ECNTRL_ETHER_EN, gemac_base + EMAC_ECNTRL_REG);
}
static inline void pfe_gemac_set_speed(void *gemac_base, u32 speed)
{
struct ccsr_scfg *scfg = (struct ccsr_scfg *)CFG_SYS_FSL_SCFG_ADDR;
u32 ecr = readl(gemac_base + EMAC_ECNTRL_REG) & ~EMAC_ECNTRL_SPEED;
u32 rcr = readl(gemac_base + EMAC_RCNTRL_REG) & ~EMAC_RCNTRL_RMII_10T;
u32 rgmii_pcr = in_be32(&scfg->rgmiipcr) &
~(SCFG_RGMIIPCR_SETSP_1000M | SCFG_RGMIIPCR_SETSP_10M);
if (speed == _1000BASET) {
ecr |= EMAC_ECNTRL_SPEED;
rgmii_pcr |= SCFG_RGMIIPCR_SETSP_1000M;
} else if (speed != _100BASET) {
rcr |= EMAC_RCNTRL_RMII_10T;
rgmii_pcr |= SCFG_RGMIIPCR_SETSP_10M;
}
writel(ecr, gemac_base + EMAC_ECNTRL_REG);
out_be32(&scfg->rgmiipcr, rgmii_pcr | SCFG_RGMIIPCR_SETFD);
/* remove loop back */
rcr &= ~EMAC_RCNTRL_LOOP;
/* enable flow control */
rcr |= EMAC_RCNTRL_FCE;
/* Enable MII mode */
rcr |= EMAC_RCNTRL_MII_MODE;
writel(rcr, gemac_base + EMAC_RCNTRL_REG);
/* Enable Tx full duplex */
writel(readl(gemac_base + EMAC_TCNTRL_REG) | EMAC_TCNTRL_FDEN,
gemac_base + EMAC_TCNTRL_REG);
}
static int pfe_eth_write_hwaddr(struct udevice *dev)
{
struct pfe_eth_dev *priv = dev_get_priv(dev);
struct gemac_s *gem = priv->gem;
struct eth_pdata *pdata = dev_get_plat(dev);
uchar *mac = pdata->enetaddr;
writel((mac[0] << 24) + (mac[1] << 16) + (mac[2] << 8) + mac[3],
gem->gemac_base + EMAC_PHY_ADDR_LOW);
writel((mac[4] << 24) + (mac[5] << 16) + 0x8808, gem->gemac_base +
EMAC_PHY_ADDR_HIGH);
return 0;
}
/** Stops or Disables GEMAC pointing to this eth iface.
*
* @param[in] edev Pointer to eth device structure.
*
* Return: none
*/
static inline void pfe_eth_stop(struct udevice *dev)
{
struct pfe_eth_dev *priv = dev_get_priv(dev);
pfe_gemac_disable(priv->gem->gemac_base);
gpi_disable(priv->gem->egpi_base);
}
static int pfe_eth_start(struct udevice *dev)
{
struct pfe_eth_dev *priv = dev_get_priv(dev);
struct gemac_s *gem = priv->gem;
int speed;
/* set ethernet mac address */
pfe_eth_write_hwaddr(dev);
writel(EMAC_TFWR, gem->gemac_base + EMAC_TFWR_STR_FWD);
writel(EMAC_RX_SECTION_FULL_32, gem->gemac_base + EMAC_RX_SECTIOM_FULL);
writel(EMAC_TRUNC_FL_16K, gem->gemac_base + EMAC_TRUNC_FL);
writel(EMAC_TX_SECTION_EMPTY_30, gem->gemac_base
+ EMAC_TX_SECTION_EMPTY);
writel(EMAC_MIBC_NO_CLR_NO_DIS, gem->gemac_base
+ EMAC_MIB_CTRL_STS_REG);
#ifdef CONFIG_PHYLIB
/* Start up the PHY */
if (phy_startup(priv->phydev)) {
printf("Could not initialize PHY %s\n",
priv->phydev->dev->name);
return -1;
}
speed = priv->phydev->speed;
printf("Speed detected %x\n", speed);
if (priv->phydev->duplex == DUPLEX_HALF) {
printf("Half duplex not supported\n");
return -1;
}
#endif
pfe_gemac_set_speed(gem->gemac_base, speed);
/* Enable GPI */
gpi_enable(gem->egpi_base);
/* Enable GEMAC */
pfe_gemac_enable(gem->gemac_base);
return 0;
}
static int pfe_eth_send(struct udevice *dev, void *packet, int length)
{
struct pfe_eth_dev *priv = (struct pfe_eth_dev *)dev_get_priv(dev);
int rc;
int i = 0;
rc = pfe_send(priv->gemac_port, packet, length);
if (rc < 0) {
printf("Tx Queue full\n");
return rc;
}
while (1) {
rc = pfe_tx_done();
if (rc == 0)
break;
udelay(100);
i++;
if (i == 30000) {
printf("Tx timeout, send failed\n");
break;
}
}
return 0;
}
static int pfe_eth_recv(struct udevice *dev, int flags, uchar **packetp)
{
struct pfe_eth_dev *priv = dev_get_priv(dev);
uchar *pkt_buf;
int len;
int phy_port;
len = pfe_recv(&pkt_buf, &phy_port);
if (len == 0)
return -EAGAIN; /* no packet in rx */
else if (len < 0)
return -EAGAIN;
debug("Rx pkt: pkt_buf(0x%p), phy_port(%d), len(%d)\n", pkt_buf,
phy_port, len);
if (phy_port != priv->gemac_port) {
printf("Rx pkt not on expected port\n");
return -EAGAIN;
}
*packetp = pkt_buf;
return len;
}
static int pfe_eth_probe(struct udevice *dev)
{
struct pfe_eth_dev *priv = dev_get_priv(dev);
struct pfe_ddr_address pfe_addr;
struct pfe_eth_pdata *pdata = dev_get_plat(dev);
int ret = 0;
static int init_done;
if (!init_done) {
pfe_addr.ddr_pfe_baseaddr =
(void *)pdata->pfe_ddr_addr.ddr_pfe_baseaddr;
pfe_addr.ddr_pfe_phys_baseaddr =
(unsigned long)pdata->pfe_ddr_addr.ddr_pfe_phys_baseaddr;
debug("ddr_pfe_baseaddr: %p, ddr_pfe_phys_baseaddr: %08x\n",
pfe_addr.ddr_pfe_baseaddr,
(u32)pfe_addr.ddr_pfe_phys_baseaddr);
ret = pfe_drv_init(&pfe_addr);
if (ret)
return ret;
init_pfe_scfg_dcfg_regs();
init_done = 1;
}
priv->gemac_port = pdata->pfe_eth_pdata_mac.phy_interface;
priv->gem = &gem_info[priv->gemac_port];
priv->dev = dev;
switch (priv->gemac_port) {
case EMAC_PORT_0:
default:
priv->gem->gemac_base = EMAC1_BASE_ADDR;
priv->gem->egpi_base = EGPI1_BASE_ADDR;
break;
case EMAC_PORT_1:
priv->gem->gemac_base = EMAC2_BASE_ADDR;
priv->gem->egpi_base = EGPI2_BASE_ADDR;
break;
}
ret = pfe_eth_board_init(dev);
if (ret)
return ret;
#if defined(CONFIG_PHYLIB)
ret = pfe_phy_configure(priv, pdata->pfe_eth_pdata_mac.phy_interface,
gem_info[priv->gemac_port].phy_address);
#endif
return ret;
}
static int pfe_eth_bind(struct udevice *dev)
{
struct pfe_eth_pdata *pdata = dev_get_plat(dev);
char name[20];
sprintf(name, "pfe_eth%u", pdata->pfe_eth_pdata_mac.phy_interface);
return device_set_name(dev, name);
}
static const struct eth_ops pfe_eth_ops = {
.start = pfe_eth_start,
.send = pfe_eth_send,
.recv = pfe_eth_recv,
.free_pkt = pfe_eth_free_pkt,
.stop = pfe_eth_stop,
.write_hwaddr = pfe_eth_write_hwaddr,
};
U_BOOT_DRIVER(pfe_eth) = {
.name = "pfe_eth",
.id = UCLASS_ETH,
.bind = pfe_eth_bind,
.probe = pfe_eth_probe,
.remove = pfe_eth_remove,
.ops = &pfe_eth_ops,
.priv_auto = sizeof(struct pfe_eth_dev),
.plat_auto = sizeof(struct pfe_eth_pdata)
};