| CONFIG_ARM=y |
| CONFIG_ARCH_MX6=y |
| CONFIG_TEXT_BASE=0x87800000 |
| CONFIG_SYS_MALLOC_LEN=0x300000 |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_SF_DEFAULT_SPEED=40000000 |
| CONFIG_ENV_SIZE=0x2000 |
| CONFIG_ENV_OFFSET=0x80000 |
| CONFIG_MX6SX=y |
| CONFIG_TARGET_MX6SXSABREAUTO=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="imx6sx-sabreauto" |
| # CONFIG_CMD_BMODE is not set |
| CONFIG_SUPPORT_RAW_INITRD=y |
| CONFIG_USE_BOOTCOMMAND=y |
| CONFIG_BOOTCOMMAND="mmc dev ${mmcdev};mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else run netboot; fi" |
| CONFIG_SYS_PBSIZE=532 |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_MAXARGS=32 |
| CONFIG_CMD_BOOTZ=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND_TRIMFFS=y |
| CONFIG_CMD_USB=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_CACHE=y |
| CONFIG_CMD_TIME=y |
| CONFIG_CMD_REGULATOR=y |
| CONFIG_CMD_EXT2=y |
| CONFIG_CMD_EXT4=y |
| CONFIG_CMD_EXT4_WRITE=y |
| CONFIG_CMD_FAT=y |
| CONFIG_CMD_FS_GENERIC=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="FEC" |
| CONFIG_BOUNCE_BUFFER=y |
| CONFIG_DM_PCA953X=y |
| CONFIG_DM_I2C=y |
| CONFIG_SYS_I2C_MXC=y |
| CONFIG_FSL_USDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_MXS=y |
| CONFIG_SYS_NAND_ONFI_DETECTION=y |
| CONFIG_DM_SPI_FLASH=y |
| CONFIG_SPI_FLASH_STMICRO=y |
| CONFIG_PHYLIB=y |
| CONFIG_PHY_ATHEROS=y |
| CONFIG_FEC_MXC=y |
| CONFIG_MII=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_IMX6=y |
| CONFIG_DM_PMIC=y |
| CONFIG_DM_PMIC_PFUZE100=y |
| CONFIG_DM_REGULATOR=y |
| CONFIG_DM_REGULATOR_PFUZE100=y |
| CONFIG_DM_REGULATOR_FIXED=y |
| CONFIG_DM_REGULATOR_GPIO=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_MXC_UART=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_FSL_QSPI=y |
| CONFIG_IMX_THERMAL=y |
| CONFIG_USB=y |
| CONFIG_USB_STORAGE=y |
| CONFIG_USB_HOST_ETHER=y |
| CONFIG_USB_ETHER_ASIX=y |
