blob: 5807c5d5ccb6ece9fa05438f5e0a1b19cfde73c0 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
/*
* Copyright (c) 2022 MediaTek Inc.
* Author: Sam Shih <sam.shih@mediatek.com>
*/
/dts-v1/;
#include "mt7986.dtsi"
#include <dt-bindings/gpio/gpio.h>
/ {
#address-cells = <1>;
#size-cells = <1>;
model = "mt7986-rfb";
compatible = "mediatek,mt7986", "mediatek,mt7986-rfb",
"mediatek,mt7986-sd-rfb";
chosen {
stdout-path = &uart0;
tick-timer = &timer0;
};
reg_3p3v: regulator-3p3v {
compatible = "regulator-fixed";
regulator-name = "fixed-3.3V";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-boot-on;
regulator-always-on;
};
};
&uart0 {
status = "okay";
};
&uart1 {
pinctrl-names = "default";
pinctrl-0 = <&uart1_pins>;
status = "disabled";
};
&eth {
status = "okay";
mediatek,gmac-id = <0>;
phy-mode = "sgmii";
mediatek,switch = "mt7531";
reset-gpios = <&gpio 5 GPIO_ACTIVE_HIGH>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
&pinctrl {
spi_flash_pins: spi0-pins-func-1 {
mux {
function = "flash";
groups = "spi0", "spi0_wp_hold";
};
conf-pu {
pins = "SPI2_CS", "SPI2_HOLD", "SPI2_WP";
drive-strength = <MTK_DRIVE_8mA>;
bias-pull-up = <MTK_PUPD_SET_R1R0_11>;
};
conf-pd {
pins = "SPI2_CLK", "SPI2_MOSI", "SPI2_MISO";
drive-strength = <MTK_DRIVE_8mA>;
bias-pull-down = <MTK_PUPD_SET_R1R0_11>;
};
};
spic_pins: spi1-pins-func-1 {
mux {
function = "spi";
groups = "spi1_2";
};
};
uart1_pins: spi1-pins-func-3 {
mux {
function = "uart";
groups = "uart1_2";
};
};
pwm_pins: pwm0-pins-func-1 {
mux {
function = "pwm";
groups = "pwm0";
};
};
mmc0_pins_default: mmc0default {
mux {
function = "flash";
groups = "emmc_51";
};
conf-cmd-dat {
pins = "EMMC_DATA_0", "EMMC_DATA_1", "EMMC_DATA_2",
"EMMC_DATA_3", "EMMC_DATA_4", "EMMC_DATA_5",
"EMMC_DATA_6", "EMMC_DATA_7", "EMMC_CMD";
input-enable;
drive-strength = <MTK_DRIVE_4mA>;
bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
};
conf-clk {
pins = "EMMC_CK";
drive-strength = <MTK_DRIVE_6mA>;
bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
};
conf-dsl {
pins = "EMMC_DSL";
bias-pull-down = <MTK_PUPD_SET_R1R0_10>;
};
conf-rst {
pins = "EMMC_RSTB";
drive-strength = <MTK_DRIVE_4mA>;
bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
};
};
};
&spi0 {
#address-cells = <1>;
#size-cells = <0>;
pinctrl-names = "default";
pinctrl-0 = <&spi_flash_pins>;
status = "okay";
must_tx;
enhance_timing;
dma_ext;
ipm_design;
support_quad;
tick_dly = <2>;
sample_sel = <0>;
spi_nor@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <52000000>;
};
spi_nand@1 {
compatible = "spi-nand";
reg = <1>;
spi-max-frequency = <52000000>;
};
};
&pwm {
pinctrl-names = "default";
pinctrl-0 = <&pwm_pins>;
status = "okay";
};
&watchdog {
status = "disabled";
};
&mmc0 {
pinctrl-names = "default";
pinctrl-0 = <&mmc0_pins_default>;
bus-width = <4>;
max-frequency = <52000000>;
cap-sd-highspeed;
r_smpl = <1>;
vmmc-supply = <&reg_3p3v>;
vqmmc-supply = <&reg_3p3v>;
status = "okay";
};