blob: 969ad484864d80bd860468b31123ff25145f5413 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
/*
* Copyright (C) 2020, STMicroelectronics - All Rights Reserved
*/
#define LOG_CATEGORY LOGC_BOARD
#include <common.h>
#include <dm.h>
#include <log.h>
#include <asm/io.h>
#include <asm/arch/ddr.h>
#include <linux/bitops.h>
#include <linux/delay.h>
#include <power/pmic.h>
#include <power/stpmic1.h>
int board_ddr_power_init(enum ddr_type ddr_type)
{
struct udevice *dev;
bool buck3_at_1800000v = false;
int ret;
u32 buck2;
ret = uclass_get_device_by_driver(UCLASS_PMIC,
DM_DRIVER_GET(pmic_stpmic1), &dev);
if (ret)
/* No PMIC on board */
return 0;
switch (ddr_type) {
case STM32MP_DDR3:
/* VTT = Set LDO3 to sync mode */
ret = pmic_reg_read(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3));
if (ret < 0)
return ret;
ret &= ~STPMIC1_LDO3_MODE;
ret &= ~STPMIC1_LDO12356_VOUT_MASK;
ret |= STPMIC1_LDO_VOUT(STPMIC1_LDO3_DDR_SEL);
ret = pmic_reg_write(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
ret);
if (ret < 0)
return ret;
/* VDD_DDR = Set BUCK2 to 1.35V */
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_VOUT_MASK,
STPMIC1_BUCK2_1350000V);
if (ret < 0)
return ret;
/* Enable VDD_DDR = BUCK2 */
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_ENA, STPMIC1_BUCK_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable VREF */
ret = pmic_clrsetbits(dev, STPMIC1_REFDDR_MAIN_CR,
STPMIC1_VREF_ENA, STPMIC1_VREF_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable VTT = LDO3 */
ret = pmic_clrsetbits(dev,
STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
STPMIC1_LDO_ENA, STPMIC1_LDO_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
break;
case STM32MP_LPDDR2_16:
case STM32MP_LPDDR2_32:
case STM32MP_LPDDR3_16:
case STM32MP_LPDDR3_32:
/*
* configure VDD_DDR1 = LDO3
* Set LDO3 to 1.8V
* + bypass mode if BUCK3 = 1.8V
* + normal mode if BUCK3 != 1.8V
*/
ret = pmic_reg_read(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK3));
if (ret < 0)
return ret;
if ((ret & STPMIC1_BUCK3_1800000V) == STPMIC1_BUCK3_1800000V)
buck3_at_1800000v = true;
ret = pmic_reg_read(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3));
if (ret < 0)
return ret;
ret &= ~STPMIC1_LDO3_MODE;
ret &= ~STPMIC1_LDO12356_VOUT_MASK;
ret |= STPMIC1_LDO3_1800000;
if (buck3_at_1800000v)
ret |= STPMIC1_LDO3_MODE;
ret = pmic_reg_write(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
ret);
if (ret < 0)
return ret;
/* VDD_DDR2 : Set BUCK2 to 1.2V (16bits) or 1.25V (32 bits)*/
switch (ddr_type) {
case STM32MP_LPDDR2_32:
case STM32MP_LPDDR3_32:
buck2 = STPMIC1_BUCK2_1250000V;
break;
default:
case STM32MP_LPDDR2_16:
case STM32MP_LPDDR3_16:
buck2 = STPMIC1_BUCK2_1200000V;
break;
}
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_VOUT_MASK,
buck2);
if (ret < 0)
return ret;
/* Enable VDD_DDR1 = LDO3 */
ret = pmic_clrsetbits(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
STPMIC1_LDO_ENA, STPMIC1_LDO_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable VDD_DDR2 =BUCK2 */
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_ENA, STPMIC1_BUCK_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable VREF */
ret = pmic_clrsetbits(dev, STPMIC1_REFDDR_MAIN_CR,
STPMIC1_VREF_ENA, STPMIC1_VREF_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
break;
default:
break;
};
return 0;
}
static int stmpic_buck1_set(struct udevice *dev, u32 voltage_mv)
{
u32 value;
/* VDDCORE= STMPCI1 BUCK1 ramp=+25mV, 5 => 725mV, 36 => 1500mV */
value = ((voltage_mv - 725) / 25) + 5;
if (value < 5)
value = 5;
if (value > 36)
value = 36;
return pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK1),
STPMIC1_BUCK_VOUT_MASK,
STPMIC1_BUCK_VOUT(value));
}
/* early init of PMIC */
struct udevice *stpmic1_init(u32 voltage_mv)
{
struct udevice *dev;
if (uclass_get_device_by_driver(UCLASS_PMIC,
DM_DRIVER_GET(pmic_stpmic1), &dev))
return NULL;
/* update VDDCORE = BUCK1 */
if (voltage_mv)
stmpic_buck1_set(dev, voltage_mv);
return dev;
}