blob: 0676587c38a1058807c36328f3bea7ab1dc05629 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* DHCOM DH-iMX6 PDK board support
*
* Copyright (C) 2017 Marek Vasut <marex@denx.de>
*/
#include <common.h>
#include <dm.h>
#include <eeprom.h>
#include <image.h>
#include <init.h>
#include <net.h>
#include <asm/global_data.h>
#include <dm/device-internal.h>
#include <asm/arch/clock.h>
#include <asm/arch/crm_regs.h>
#include <asm/arch/imx-regs.h>
#include <asm/arch/iomux.h>
#include <asm/arch/mx6-pins.h>
#include <asm/arch/sys_proto.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/mach-imx/boot_mode.h>
#include <asm/mach-imx/iomux-v3.h>
#include <asm/mach-imx/sata.h>
#include <ahci.h>
#include <dwc_ahsata.h>
#include <env.h>
#include <errno.h>
#include <fsl_esdhc_imx.h>
#include <fuse.h>
#include <i2c_eeprom.h>
#include <mmc.h>
#include <usb.h>
#include <linux/delay.h>
#include <usb/ehci-ci.h>
#include "../common/dh_common.h"
#include "../common/dh_imx.h"
DECLARE_GLOBAL_DATA_PTR;
int dram_init(void)
{
gd->ram_size = imx_ddr_size();
return 0;
}
/*
* Do not overwrite the console
* Use always serial for U-Boot console
*/
int overwrite_console(void)
{
return 1;
}
static int setup_fec_clock(void)
{
struct iomuxc *iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
/* set gpr1[21] to select anatop clock */
clrsetbits_le32(&iomuxc_regs->gpr[1], 0x1 << 21, 0x1 << 21);
return enable_fec_anatop_clock(0, ENET_50MHZ);
}
#ifdef CONFIG_USB_EHCI_MX6
static void setup_usb(void)
{
/*
* Set daisy chain for otg_pin_id on MX6Q.
* For MX6DL, this bit is reserved.
*/
imx_iomux_set_gpr_register(1, 13, 1, 0);
}
int board_usb_phy_mode(int port)
{
if (port == 1)
return USB_INIT_HOST;
else
return USB_INIT_DEVICE;
}
#endif
int dh_setup_mac_address(void)
{
unsigned char enetaddr[6];
if (dh_mac_is_in_env("ethaddr"))
return 0;
if (dh_get_mac_is_enabled("ethernet0"))
return 0;
if (!dh_imx_get_mac_from_fuse(enetaddr))
goto out;
if (!dh_get_mac_from_eeprom(enetaddr, "eeprom0"))
goto out;
printf("%s: Unable to get MAC address!\n", __func__);
return -ENXIO;
out:
return eth_env_set_enetaddr("ethaddr", enetaddr);
}
int board_early_init_f(void)
{
#ifdef CONFIG_USB_EHCI_MX6
setup_usb();
#endif
return 0;
}
int board_init(void)
{
struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
/* address of boot parameters */
gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
/* Enable eim_slow clocks */
setbits_le32(&mxc_ccm->CCGR6, 0x1 << MXC_CCM_CCGR6_EMI_SLOW_OFFSET);
setup_fec_clock();
return 0;
}
#ifdef CONFIG_CMD_BMODE
static const struct boot_mode board_boot_modes[] = {
/* 4 bit bus width */
{"sd2", MAKE_CFGVAL(0x40, 0x28, 0x00, 0x00)},
{"sd3", MAKE_CFGVAL(0x40, 0x30, 0x00, 0x00)},
/* 8 bit bus width */
{"emmc", MAKE_CFGVAL(0x60, 0x58, 0x00, 0x00)},
{NULL, 0},
};
#endif
#define HW_CODE_BIT_0 IMX_GPIO_NR(2, 19)
#define HW_CODE_BIT_1 IMX_GPIO_NR(6, 6)
#define HW_CODE_BIT_2 IMX_GPIO_NR(2, 16)
static int board_get_hwcode(void)
{
int hw_code;
gpio_request(HW_CODE_BIT_0, "HW-code-bit-0");
gpio_request(HW_CODE_BIT_1, "HW-code-bit-1");
gpio_request(HW_CODE_BIT_2, "HW-code-bit-2");
gpio_direction_input(HW_CODE_BIT_0);
gpio_direction_input(HW_CODE_BIT_1);
gpio_direction_input(HW_CODE_BIT_2);
/* HW 100 + HW 200 = 00b; HW 300 = 01b */
hw_code = ((gpio_get_value(HW_CODE_BIT_2) << 2) |
(gpio_get_value(HW_CODE_BIT_1) << 1) |
gpio_get_value(HW_CODE_BIT_0)) + 2;
return hw_code;
}
int board_late_init(void)
{
u32 hw_code;
char buf[16];
dh_setup_mac_address();
hw_code = board_get_hwcode();
switch (get_cpu_type()) {
case MXC_CPU_MX6SOLO:
snprintf(buf, sizeof(buf), "imx6s-dhcom%1d", hw_code);
break;
case MXC_CPU_MX6DL:
snprintf(buf, sizeof(buf), "imx6dl-dhcom%1d", hw_code);
break;
case MXC_CPU_MX6D:
snprintf(buf, sizeof(buf), "imx6d-dhcom%1d", hw_code);
break;
case MXC_CPU_MX6Q:
snprintf(buf, sizeof(buf), "imx6q-dhcom%1d", hw_code);
break;
default:
snprintf(buf, sizeof(buf), "UNKNOWN%1d", hw_code);
break;
}
env_set("dhcom", buf);
#ifdef CONFIG_CMD_BMODE
add_board_boot_modes(board_boot_modes);
#endif
return 0;
}
int checkboard(void)
{
puts("Board: DHCOM i.MX6\n");
return 0;
}
#ifdef CONFIG_MULTI_DTB_FIT
static int strcmp_prefix(const char *s1, const char *s2)
{
size_t n;
n = min(strlen(s1), strlen(s2));
return strncmp(s1, s2, n);
}
int board_fit_config_name_match(const char *name)
{
char *want;
char *have;
/* Test Board suffix, e.g. -dhcom-drc02 */
want = strchr(CONFIG_DEFAULT_DEVICE_TREE, '-');
have = strchr(name, '-');
if (!want || !have || strcmp(want, have))
return -EINVAL;
/* Test SoC prefix */
if (is_mx6dq() && !strcmp_prefix(name, "imx6q-"))
return 0;
if (is_mx6sdl()) {
if (!strcmp_prefix(name, "imx6s-") || !strcmp_prefix(name, "imx6dl-"))
return 0;
}
return -EINVAL;
}
#endif