| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Holtek HT1380/HT1381 Serial Timekeeper Chip |
| * |
| * Communication with the chip is vendor-specific. |
| * It is done via 3 GPIO pins: reset, clock, and data. |
| * Describe in .dts this way: |
| * |
| * rtc { |
| * compatible = "holtek,ht1380"; |
| * rst-gpios = <&gpio 19 GPIO_ACTIVE_LOW>; |
| * clk-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>; |
| * dat-gpios = <&gpio 21 GPIO_ACTIVE_HIGH>; |
| * }; |
| * |
| */ |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <rtc.h> |
| #include <bcd.h> |
| #include <asm/gpio.h> |
| #include <linux/delay.h> |
| |
| struct ht1380_priv { |
| struct gpio_desc rst_desc; |
| struct gpio_desc clk_desc; |
| struct gpio_desc dat_desc; |
| }; |
| |
| enum registers { |
| SEC, |
| MIN, |
| HOUR, |
| MDAY, |
| MONTH, |
| WDAY, |
| YEAR, |
| WP, |
| N_REGS |
| }; |
| |
| enum hour_mode { |
| AMPM_MODE = 0x80, /* RTC is in AM/PM mode */ |
| PM_NOW = 0x20, /* set if PM, clear if AM */ |
| }; |
| |
| static const int BURST = 0xbe; |
| static const int READ = 1; |
| |
| static void ht1380_half_period_delay(void) |
| { |
| /* |
| * Delay for half a period. 1 us complies with the 500 KHz maximum |
| * input serial clock limit given by the datasheet. |
| */ |
| udelay(1); |
| } |
| |
| static int ht1380_send_byte(struct ht1380_priv *priv, int byte) |
| { |
| int ret; |
| |
| for (int bit = 0; bit < 8; bit++) { |
| ret = dm_gpio_set_value(&priv->dat_desc, byte >> bit & 1); |
| if (ret) |
| break; |
| ht1380_half_period_delay(); |
| |
| ret = dm_gpio_set_value(&priv->clk_desc, 1); |
| if (ret) |
| break; |
| ht1380_half_period_delay(); |
| |
| ret = dm_gpio_set_value(&priv->clk_desc, 0); |
| if (ret) |
| break; |
| } |
| |
| return ret; |
| } |
| |
| /* |
| * Leave reset state. The transfer operation can then be started. |
| */ |
| static int ht1380_reset_off(struct ht1380_priv *priv) |
| { |
| const unsigned int T_CC = 4; /* us, Reset to Clock Setup */ |
| int ret; |
| |
| /* |
| * Leave RESET state. |
| * Make sure we make the minimal delay required by the datasheet. |
| */ |
| ret = dm_gpio_set_value(&priv->rst_desc, 0); |
| udelay(T_CC); |
| |
| return ret; |
| } |
| |
| /* |
| * Enter reset state. Completes the transfer operation. |
| */ |
| static int ht1380_reset_on(struct ht1380_priv *priv) |
| { |
| const unsigned int T_CWH = 4; /* us, Reset Inactive Time */ |
| int ret; |
| |
| /* |
| * Enter RESET state. |
| * Make sure we make the minimal delay required by the datasheet. |
| */ |
| ret = dm_gpio_set_value(&priv->rst_desc, 1); |
| udelay(T_CWH); |
| |
| return ret; |
| } |
| |
| static int ht1380_rtc_get(struct udevice *dev, struct rtc_time *tm) |
| { |
| struct ht1380_priv *priv = dev_get_priv(dev); |
| int ret, i, bit, reg[N_REGS]; |
| |
| ret = dm_gpio_set_value(&priv->clk_desc, 0); |
| if (ret) |
| return ret; |
| |
| ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT); |
| if (ret) |
| return ret; |
| |
| ret = ht1380_reset_off(priv); |
| if (ret) |
| goto exit; |
| |
| ret = ht1380_send_byte(priv, BURST + READ); |
| if (ret) |
| goto exit; |
| |
| ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_IN); |
| if (ret) |
| goto exit; |
| |
| for (i = 0; i < N_REGS; i++) { |
| reg[i] = 0; |
| |
| for (bit = 0; bit < 8; bit++) { |
| ht1380_half_period_delay(); |
| |
| ret = dm_gpio_set_value(&priv->clk_desc, 1); |
| if (ret) |
| goto exit; |
| ht1380_half_period_delay(); |
| |
| reg[i] |= dm_gpio_get_value(&priv->dat_desc) << bit; |
| ret = dm_gpio_set_value(&priv->clk_desc, 0); |
| if (ret) |
| goto exit; |
| } |
| } |
| |
| ret = -EINVAL; |
| |
| /* Correctness check: some bits are always zero */ |
| if (reg[MIN] & 0x80 || reg[HOUR] & 0x40 || reg[MDAY] & 0xc0 || |
| reg[MONTH] & 0xe0 || reg[WDAY] & 0xf8 || reg[WP] & 0x7f) |
| goto exit; |
| |
| /* Correctness check: some registers are always non-zero */ |
| if (!reg[MDAY] || !reg[MONTH] || !reg[WDAY]) |
| goto exit; |
| |
| tm->tm_sec = bcd2bin(reg[SEC]); |
| tm->tm_min = bcd2bin(reg[MIN]); |
| if (reg[HOUR] & AMPM_MODE) { |
| /* AM-PM Mode, range is 01-12 */ |
| tm->tm_hour = bcd2bin(reg[HOUR] & 0x1f) % 12; |
| if (reg[HOUR] & PM_NOW) { |
| /* it is PM (otherwise AM) */ |
| tm->tm_hour += 12; |
| } |
| } else { |
| /* 24-hour Mode, range is 0-23 */ |
| tm->tm_hour = bcd2bin(reg[HOUR]); |
| } |
| tm->tm_mday = bcd2bin(reg[MDAY]); |
| tm->tm_mon = bcd2bin(reg[MONTH]); |
| tm->tm_year = 2000 + bcd2bin(reg[YEAR]); |
| tm->tm_wday = bcd2bin(reg[WDAY]) - 1; |
| tm->tm_yday = 0; |
| tm->tm_isdst = 0; |
| |
| ret = 0; |
| |
| exit: |
| ht1380_reset_on(priv); |
| |
| return ret; |
| } |
| |
| static int ht1380_write_protection_off(struct ht1380_priv *priv) |
| { |
| int ret; |
| const int PROTECT = 0x8e; |
| |
| ret = ht1380_reset_off(priv); |
| if (ret) |
| return ret; |
| |
| ret = ht1380_send_byte(priv, PROTECT); |
| if (ret) |
| return ret; |
| ret = ht1380_send_byte(priv, 0); /* WP bit is 0 */ |
| if (ret) |
| return ret; |
| |
| return ht1380_reset_on(priv); |
| } |
| |
| static int ht1380_rtc_set(struct udevice *dev, const struct rtc_time *tm) |
| { |
| struct ht1380_priv *priv = dev_get_priv(dev); |
| int ret, i, reg[N_REGS]; |
| |
| ret = dm_gpio_set_value(&priv->clk_desc, 0); |
| if (ret) |
| return ret; |
| |
| ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT); |
| if (ret) |
| goto exit; |
| |
| ret = ht1380_write_protection_off(priv); |
| if (ret) |
| goto exit; |
| |
| reg[SEC] = bin2bcd(tm->tm_sec); |
| reg[MIN] = bin2bcd(tm->tm_min); |
| reg[HOUR] = bin2bcd(tm->tm_hour); |
| reg[MDAY] = bin2bcd(tm->tm_mday); |
| reg[MONTH] = bin2bcd(tm->tm_mon); |
| reg[WDAY] = bin2bcd(tm->tm_wday) + 1; |
| reg[YEAR] = bin2bcd(tm->tm_year - 2000); |
| reg[WP] = 0x80; /* WP bit is 1 */ |
| |
| ret = ht1380_reset_off(priv); |
| if (ret) |
| goto exit; |
| |
| ret = ht1380_send_byte(priv, BURST); |
| for (i = 0; i < N_REGS && ret; i++) |
| ret = ht1380_send_byte(priv, reg[i]); |
| |
| exit: |
| ht1380_reset_on(priv); |
| |
| return ret; |
| } |
| |
| static int ht1380_probe(struct udevice *dev) |
| { |
| int ret; |
| struct ht1380_priv *priv; |
| |
| priv = dev_get_priv(dev); |
| if (!priv) |
| return -EINVAL; |
| |
| ret = gpio_request_by_name(dev, "rst-gpios", 0, |
| &priv->rst_desc, GPIOD_IS_OUT); |
| if (ret) |
| goto fail_rst; |
| |
| ret = gpio_request_by_name(dev, "clk-gpios", 0, |
| &priv->clk_desc, GPIOD_IS_OUT); |
| if (ret) |
| goto fail_clk; |
| |
| ret = gpio_request_by_name(dev, "dat-gpios", 0, |
| &priv->dat_desc, 0); |
| if (ret) |
| goto fail_dat; |
| |
| ret = ht1380_reset_on(priv); |
| if (ret) |
| goto fail; |
| |
| return 0; |
| |
| fail: |
| dm_gpio_free(dev, &priv->dat_desc); |
| fail_dat: |
| dm_gpio_free(dev, &priv->clk_desc); |
| fail_clk: |
| dm_gpio_free(dev, &priv->rst_desc); |
| fail_rst: |
| return ret; |
| } |
| |
| static int ht1380_remove(struct udevice *dev) |
| { |
| struct ht1380_priv *priv = dev_get_priv(dev); |
| |
| dm_gpio_free(dev, &priv->rst_desc); |
| dm_gpio_free(dev, &priv->clk_desc); |
| dm_gpio_free(dev, &priv->dat_desc); |
| |
| return 0; |
| } |
| |
| static const struct rtc_ops ht1380_rtc_ops = { |
| .get = ht1380_rtc_get, |
| .set = ht1380_rtc_set, |
| }; |
| |
| static const struct udevice_id ht1380_rtc_ids[] = { |
| { .compatible = "holtek,ht1380" }, |
| { } |
| }; |
| |
| U_BOOT_DRIVER(rtc_ht1380) = { |
| .name = "rtc-ht1380", |
| .id = UCLASS_RTC, |
| .probe = ht1380_probe, |
| .remove = ht1380_remove, |
| .of_match = ht1380_rtc_ids, |
| .ops = &ht1380_rtc_ops, |
| .priv_auto = sizeof(struct ht1380_priv), |
| }; |