| .. _skiboot-5.1.18: |
| |
| skiboot-5.1.18 |
| -------------- |
| |
| skiboot-5.1.18 was released on Friday 26th August 2016. |
| |
| skiboot-5.1.18 is the 19th stable release of 5.1, it follows skiboot-5.1.17 |
| (which was released July 21st, 2016). |
| |
| This release contains a few minor bug fixes. |
| |
| Changes are: |
| |
| All platforms: |
| |
| - opal/hmi: Fix a TOD HMI failure during a race condition. |
| Rare race condition which meant we wouldn't recover from TOD error |
| |
| - hw/phb3: Update capi initialization sequence |
| The capi initialization sequence was revised in a circumvention |
| document when a 'link down' error was converted from fatal to Endpoint |
| Recoverable. Other, non-capi, register setup was corrected even before |
| the initial open-source release of skiboot, but a few capi-related |
| registers were not updated then, so this patch fixes it. |
| The point is that a link-down error detected by the UTL logic will |
| lead to an AIB fence, so that the CAPP unit can detect the error. |
| |
| FSP platforms: |
| |
| - FSP/ELOG: Fix OPAL generated elog resend logic |
| - FSP/ELOG: Fix possible event notifier hangs |
| - FSP/ELOG: Disable event notification if list is not consistent |
| - FSP/ELOG: Fix OPAL generated elog event notification |
| - FSP/ELOG: Disable event notification during kexec |
