| skiboot-5.3.1 |
| ------------- |
| |
| skiboot-5.3.1 was released on Wednesday August 10th, 2016. |
| |
| This is the 2nd stable release of skiboot 5.3, the new stable release of |
| skiboot (first released with 5.3.0 on August 2nd, 2016). |
| |
| Skiboot 5.3.1 replaces skiboot-5.3.0 as the current stable version. It contains |
| a few minor bug fixes. |
| |
| This release follows the Skiboot stable rules, see :ref:`stable-rules`. |
| |
| Over skiboot-5.3.0, the following fixes are included: |
| |
| FSP systems: |
| |
| - FSP/ELOG: elog_enable flag should be false by default |
| This issue is one of the corner case, which is related to recent change |
| went upstream and only observed in the petitboot prompt, where we see |
| only one error log instead of getting all error log in |
| /sys/firmware/opal/elog. |
| |
| NVLink systems (i.e. Garrison): |
| |
| - npu: reword "error" to indicate it's actually a warning |
| Without this patch, you get spurious FirmWare Test Suite (FWTS) warnings |
| about NVLink not working on machines that aren't fully populated with |
| GPUs. |
| - hmi: Clean up NPU FIR debug messages |
| With the skiboot log set to debug, the FIR (and related registers) were |
| logged all in the same message. It was too much for one line, didn't |
| clarify if the numbers were in hex, and didn't show leading zeroes. |
| |
| General: |
| |
| - asm: Fix backtrace for unexpected exception |
| - correct the log level from PR_ERROR down to PR_INFO for some skiboot |
| log messages. |
