blob: 5c4f6e1818b8943adc8474d4af5ce159cd19561e [file] [log] [blame]
#ifndef __AHCI_H
#define __AHCI_H
#include "block.h" // struct drive_s
#include "types.h" // u32
struct sata_cmd_fis {
u8 reg;
u8 pmp_type;
u8 command;
u8 feature;
u8 lba_low;
u8 lba_mid;
u8 lba_high;
u8 device;
u8 lba_low2;
u8 lba_mid2;
u8 lba_high2;
u8 feature2;
u8 sector_count;
u8 sector_count2;
u8 res_1;
u8 control;
u8 res_2[64 - 16];
};
struct ahci_ctrl_s {
struct pci_device *pci_tmp;
u8 irq;
void *iobase;
u32 caps;
u32 ports;
};
struct ahci_cmd_s {
struct sata_cmd_fis fis;
u8 atapi[0x20];
u8 res[0x20];
struct {
u32 base;
u32 baseu;
u32 res;
u32 flags;
} prdt[];
};
/* command list */
struct ahci_list_s {
u32 flags;
u32 bytes;
u32 base;
u32 baseu;
u32 res[4];
};
struct ahci_fis_s {
u8 dsfis[0x1c]; /* dma setup */
u8 res_1[0x04];
u8 psfis[0x14]; /* pio setup */
u8 res_2[0x0c];
u8 rfis[0x14]; /* d2h register */
u8 res_3[0x04];
u8 sdbfis[0x08]; /* set device bits */
u8 ufis[0x40]; /* unknown */
u8 res_4[0x60];
};
struct ahci_port_s {
struct drive_s drive;
struct ahci_ctrl_s *ctrl;
struct ahci_list_s *list;
struct ahci_fis_s *fis;
struct ahci_cmd_s *cmd;
u32 pnr;
u32 atapi;
char *desc;
int prio;
};
void ahci_setup(void);
int ahci_process_op(struct disk_op_s *op);
int ahci_atapi_process_op(struct disk_op_s *op);
#define AHCI_IRQ_ON_SG (1 << 31)
#define AHCI_CMD_ATAPI (1 << 5)
#define AHCI_CMD_WRITE (1 << 6)
#define AHCI_CMD_PREFETCH (1 << 7)
#define AHCI_CMD_RESET (1 << 8)
#define AHCI_CMD_CLR_BUSY (1 << 10)
#define RX_FIS_D2H_REG 0x40 /* offset of D2H Register FIS data */
#define RX_FIS_SDB 0x58 /* offset of SDB FIS data */
#define RX_FIS_UNK 0x60 /* offset of Unknown FIS data */
/* global controller registers */
#define HOST_CAP 0x00 /* host capabilities */
#define HOST_CTL 0x04 /* global host control */
#define HOST_IRQ_STAT 0x08 /* interrupt status */
#define HOST_PORTS_IMPL 0x0c /* bitmap of implemented ports */
#define HOST_VERSION 0x10 /* AHCI spec. version compliancy */
/* HOST_CTL bits */
#define HOST_CTL_RESET (1 << 0) /* reset controller; self-clear */
#define HOST_CTL_IRQ_EN (1 << 1) /* global IRQ enable */
#define HOST_CTL_AHCI_EN (1 << 31) /* AHCI enabled */
/* HOST_CAP bits */
#define HOST_CAP_SSC (1 << 14) /* Slumber capable */
#define HOST_CAP_AHCI (1 << 18) /* AHCI only */
#define HOST_CAP_CLO (1 << 24) /* Command List Override support */
#define HOST_CAP_SSS (1 << 27) /* Staggered Spin-up */
#define HOST_CAP_NCQ (1 << 30) /* Native Command Queueing */
#define HOST_CAP_64 (1 << 31) /* PCI DAC (64-bit DMA) support */
/* registers for each SATA port */
#define PORT_LST_ADDR 0x00 /* command list DMA addr */
#define PORT_LST_ADDR_HI 0x04 /* command list DMA addr hi */
#define PORT_FIS_ADDR 0x08 /* FIS rx buf addr */
#define PORT_FIS_ADDR_HI 0x0c /* FIS rx buf addr hi */
#define PORT_IRQ_STAT 0x10 /* interrupt status */
#define PORT_IRQ_MASK 0x14 /* interrupt enable/disable mask */
#define PORT_CMD 0x18 /* port command */
#define PORT_TFDATA 0x20 /* taskfile data */
#define PORT_SIG 0x24 /* device TF signature */
#define PORT_SCR_STAT 0x28 /* SATA phy register: SStatus */
#define PORT_SCR_CTL 0x2c /* SATA phy register: SControl */
#define PORT_SCR_ERR 0x30 /* SATA phy register: SError */
#define PORT_SCR_ACT 0x34 /* SATA phy register: SActive */
#define PORT_CMD_ISSUE 0x38 /* command issue */
#define PORT_RESERVED 0x3c /* reserved */
/* PORT_IRQ_{STAT,MASK} bits */
#define PORT_IRQ_COLD_PRES (1 << 31) /* cold presence detect */
#define PORT_IRQ_TF_ERR (1 << 30) /* task file error */
#define PORT_IRQ_HBUS_ERR (1 << 29) /* host bus fatal error */
#define PORT_IRQ_HBUS_DATA_ERR (1 << 28) /* host bus data error */
#define PORT_IRQ_IF_ERR (1 << 27) /* interface fatal error */
#define PORT_IRQ_IF_NONFATAL (1 << 26) /* interface non-fatal error */
#define PORT_IRQ_OVERFLOW (1 << 24) /* xfer exhausted available S/G */
#define PORT_IRQ_BAD_PMP (1 << 23) /* incorrect port multiplier */
#define PORT_IRQ_PHYRDY (1 << 22) /* PhyRdy changed */
#define PORT_IRQ_DEV_ILCK (1 << 7) /* device interlock */
#define PORT_IRQ_CONNECT (1 << 6) /* port connect change status */
#define PORT_IRQ_SG_DONE (1 << 5) /* descriptor processed */
#define PORT_IRQ_UNK_FIS (1 << 4) /* unknown FIS rx'd */
#define PORT_IRQ_SDB_FIS (1 << 3) /* Set Device Bits FIS rx'd */
#define PORT_IRQ_DMAS_FIS (1 << 2) /* DMA Setup FIS rx'd */
#define PORT_IRQ_PIOS_FIS (1 << 1) /* PIO Setup FIS rx'd */
#define PORT_IRQ_D2H_REG_FIS (1 << 0) /* D2H Register FIS rx'd */
#define PORT_IRQ_FREEZE (PORT_IRQ_HBUS_ERR | PORT_IRQ_IF_ERR | \
PORT_IRQ_CONNECT | PORT_IRQ_PHYRDY | \
PORT_IRQ_UNK_FIS)
#define PORT_IRQ_ERROR (PORT_IRQ_FREEZE | PORT_IRQ_TF_ERR | \
PORT_IRQ_HBUS_DATA_ERR)
#define DEF_PORT_IRQ (PORT_IRQ_ERROR | PORT_IRQ_SG_DONE | \
PORT_IRQ_SDB_FIS | PORT_IRQ_DMAS_FIS | \
PORT_IRQ_PIOS_FIS | PORT_IRQ_D2H_REG_FIS)
/* PORT_CMD bits */
#define PORT_CMD_ATAPI (1 << 24) /* Device is ATAPI */
#define PORT_CMD_LIST_ON (1 << 15) /* cmd list DMA engine running */
#define PORT_CMD_FIS_ON (1 << 14) /* FIS DMA engine running */
#define PORT_CMD_FIS_RX (1 << 4) /* Enable FIS receive DMA engine */
#define PORT_CMD_CLO (1 << 3) /* Command list override */
#define PORT_CMD_POWER_ON (1 << 2) /* Power up device */
#define PORT_CMD_SPIN_UP (1 << 1) /* Spin up device */
#define PORT_CMD_START (1 << 0) /* Enable port DMA engine */
#define PORT_CMD_ICC_MASK (0xf << 28) /* i/f ICC state mask */
#define PORT_CMD_ICC_ACTIVE (0x1 << 28) /* Put i/f in active state */
#define PORT_CMD_ICC_PARTIAL (0x2 << 28) /* Put i/f in partial state */
#define PORT_CMD_ICC_SLUMBER (0x6 << 28) /* Put i/f in slumber state */
#define PORT_IRQ_STAT_DHRS (1 << 0) /* Device to Host Register FIS */
#define PORT_IRQ_STAT_PSS (1 << 1) /* PIO Setup FIS */
#define PORT_IRQ_STAT_DSS (1 << 2) /* DMA Setup FIS */
#define PORT_IRQ_STAT_SDBS (1 << 3) /* Set Device Bits */
#define PORT_IRQ_STAT_UFS (1 << 4) /* Unknown FIS */
#define PORT_IRQ_STAT_DPS (1 << 5) /* Descriptor Processed */
#define PORT_IRQ_STAT_PCS (1 << 6) /* Port Connect Change Status */
#define PORT_IRQ_STAT_DMPS (1 << 7) /* Device Mechanical Presence
Status */
#define PORT_IRQ_STAT_PRCS (1 << 22) /* File Ready Status */
#define PORT_IRQ_STAT_IPMS (1 << 23) /* Incorrect Port Multiplier
Status */
#define PORT_IRQ_STAT_OFS (1 << 24) /* Overflow Status */
#define PORT_IRQ_STAT_INFS (1 << 26) /* Interface Non-Fatal Error
Status */
#define PORT_IRQ_STAT_IFS (1 << 27) /* Interface Fatal Error */
#define PORT_IRQ_STAT_HBDS (1 << 28) /* Host Bus Data Error Status */
#define PORT_IRQ_STAT_HBFS (1 << 29) /* Host Bus Fatal Error Status */
#define PORT_IRQ_STAT_TFES (1 << 30) /* Task File Error Status */
#define PORT_IRQ_STAT_CPDS (1 << 31) /* Code Port Detect Status */
#endif // ahci.h