| /* |
| * SuperH Timer modules. |
| * |
| * Copyright (c) 2007 Magnus Damm |
| * Based on arm_timer.c by Paul Brook |
| * Copyright (c) 2005-2006 CodeSourcery. |
| * |
| * This code is licenced under the GPL. |
| */ |
| |
| #include "hw.h" |
| #include "sh.h" |
| #include "qemu-timer.h" |
| |
| //#define DEBUG_TIMER |
| |
| #define TIMER_TCR_TPSC (7 << 0) |
| #define TIMER_TCR_CKEG (3 << 3) |
| #define TIMER_TCR_UNIE (1 << 5) |
| #define TIMER_TCR_ICPE (3 << 6) |
| #define TIMER_TCR_UNF (1 << 8) |
| #define TIMER_TCR_ICPF (1 << 9) |
| #define TIMER_TCR_RESERVED (0x3f << 10) |
| |
| #define TIMER_FEAT_CAPT (1 << 0) |
| #define TIMER_FEAT_EXTCLK (1 << 1) |
| |
| typedef struct { |
| ptimer_state *timer; |
| uint32_t tcnt; |
| uint32_t tcor; |
| uint32_t tcr; |
| uint32_t tcpr; |
| int freq; |
| int int_level; |
| int feat; |
| int enabled; |
| qemu_irq irq; |
| } sh_timer_state; |
| |
| /* Check all active timers, and schedule the next timer interrupt. */ |
| |
| static void sh_timer_update(sh_timer_state *s) |
| { |
| #if 0 /* not yet */ |
| /* Update interrupts. */ |
| if (s->int_level && (s->tcr & TIMER_TCR_UNIE)) { |
| qemu_irq_raise(s->irq); |
| } else { |
| qemu_irq_lower(s->irq); |
| } |
| #endif |
| } |
| |
| uint32_t sh_timer_read(void *opaque, target_phys_addr_t offset) |
| { |
| sh_timer_state *s = (sh_timer_state *)opaque; |
| |
| switch (offset >> 2) { |
| case 0: |
| return s->tcor; |
| case 1: |
| return ptimer_get_count(s->timer); |
| case 2: |
| return s->tcr | (s->int_level ? TIMER_TCR_UNF : 0); |
| case 3: |
| if (s->feat & TIMER_FEAT_CAPT) |
| return s->tcpr; |
| default: |
| cpu_abort (cpu_single_env, "sh_timer_read: Bad offset %x\n", |
| (int)offset); |
| return 0; |
| } |
| } |
| |
| static void sh_timer_write(void *opaque, target_phys_addr_t offset, |
| uint32_t value) |
| { |
| sh_timer_state *s = (sh_timer_state *)opaque; |
| int freq; |
| |
| switch (offset >> 2) { |
| case 0: |
| s->tcor = value; |
| ptimer_set_limit(s->timer, s->tcor, 0); |
| break; |
| case 1: |
| s->tcnt = value; |
| ptimer_set_count(s->timer, s->tcnt); |
| break; |
| case 2: |
| if (s->enabled) { |
| /* Pause the timer if it is running. This may cause some |
| inaccuracy dure to rounding, but avoids a whole lot of other |
| messyness. */ |
| ptimer_stop(s->timer); |
| } |
| freq = s->freq; |
| /* ??? Need to recalculate expiry time after changing divisor. */ |
| switch (value & TIMER_TCR_TPSC) { |
| case 0: freq >>= 2; break; |
| case 1: freq >>= 4; break; |
| case 2: freq >>= 6; break; |
| case 3: freq >>= 8; break; |
| case 4: freq >>= 10; break; |
| case 6: |
| case 7: if (s->feat & TIMER_FEAT_EXTCLK) break; |
| default: cpu_abort (cpu_single_env, |
| "sh_timer_write: Reserved TPSC value\n"); break; |
| } |
| switch ((value & TIMER_TCR_CKEG) >> 3) { |
| case 0: break; |
| case 1: |
| case 2: |
| case 3: if (s->feat & TIMER_FEAT_EXTCLK) break; |
| default: cpu_abort (cpu_single_env, |
| "sh_timer_write: Reserved CKEG value\n"); break; |
| } |
| switch ((value & TIMER_TCR_ICPE) >> 6) { |
| case 0: break; |
| case 2: |
| case 3: if (s->feat & TIMER_FEAT_CAPT) break; |
| default: cpu_abort (cpu_single_env, |
| "sh_timer_write: Reserved ICPE value\n"); break; |
| } |
| if ((value & TIMER_TCR_UNF) == 0) |
| s->int_level = 0; |
| |
| value &= ~TIMER_TCR_UNF; |
| |
| if ((value & TIMER_TCR_ICPF) && (!(s->feat & TIMER_FEAT_CAPT))) |
| cpu_abort (cpu_single_env, |
| "sh_timer_write: Reserved ICPF value\n"); |
| |
| value &= ~TIMER_TCR_ICPF; /* capture not supported */ |
| |
| if (value & TIMER_TCR_RESERVED) |
| cpu_abort (cpu_single_env, |
| "sh_timer_write: Reserved TCR bits set\n"); |
| s->tcr = value; |
| ptimer_set_limit(s->timer, s->tcor, 0); |
| ptimer_set_freq(s->timer, freq); |
| if (s->enabled) { |
| /* Restart the timer if still enabled. */ |
| ptimer_run(s->timer, 0); |
| } |
| break; |
| case 3: |
| if (s->feat & TIMER_FEAT_CAPT) { |
| s->tcpr = value; |
| break; |
| } |
| default: |
| cpu_abort (cpu_single_env, "sh_timer_write: Bad offset %x\n", |
| (int)offset); |
| } |
| sh_timer_update(s); |
| } |
| |
| static void sh_timer_start_stop(void *opaque, int enable) |
| { |
| sh_timer_state *s = (sh_timer_state *)opaque; |
| |
| #ifdef DEBUG_TIMER |
| printf("sh_timer_start_stop %d (%d)\n", enable, s->enabled); |
| #endif |
| |
| if (s->enabled && !enable) { |
| ptimer_stop(s->timer); |
| } |
| if (!s->enabled && enable) { |
| ptimer_run(s->timer, 0); |
| } |
| s->enabled = !!enable; |
| |
| #ifdef DEBUG_TIMER |
| printf("sh_timer_start_stop done %d\n", s->enabled); |
| #endif |
| } |
| |
| static void sh_timer_tick(void *opaque) |
| { |
| sh_timer_state *s = (sh_timer_state *)opaque; |
| s->int_level = s->enabled; |
| sh_timer_update(s); |
| } |
| |
| static void *sh_timer_init(uint32_t freq, int feat) |
| { |
| sh_timer_state *s; |
| QEMUBH *bh; |
| |
| s = (sh_timer_state *)qemu_mallocz(sizeof(sh_timer_state)); |
| s->freq = freq; |
| s->feat = feat; |
| s->tcor = 0xffffffff; |
| s->tcnt = 0xffffffff; |
| s->tcpr = 0xdeadbeef; |
| s->tcor = 0; |
| s->enabled = 0; |
| |
| bh = qemu_bh_new(sh_timer_tick, s); |
| s->timer = ptimer_init(bh); |
| /* ??? Save/restore. */ |
| return s; |
| } |
| |
| typedef struct { |
| void *timer[3]; |
| int level[3]; |
| uint32_t tocr; |
| uint32_t tstr; |
| target_phys_addr_t base; |
| int feat; |
| } tmu012_state; |
| |
| static uint32_t tmu012_read(void *opaque, target_phys_addr_t offset) |
| { |
| tmu012_state *s = (tmu012_state *)opaque; |
| |
| #ifdef DEBUG_TIMER |
| printf("tmu012_read 0x%lx\n", (unsigned long) offset); |
| #endif |
| offset -= s->base; |
| |
| if (offset >= 0x20) { |
| if (!(s->feat & TMU012_FEAT_3CHAN)) |
| cpu_abort (cpu_single_env, "tmu012_write: Bad channel offset %x\n", |
| (int)offset); |
| return sh_timer_read(s->timer[2], offset - 0x20); |
| } |
| |
| if (offset >= 0x14) |
| return sh_timer_read(s->timer[1], offset - 0x14); |
| |
| if (offset >= 0x08) |
| return sh_timer_read(s->timer[0], offset - 0x08); |
| |
| if (offset == 4) |
| return s->tstr; |
| |
| if ((s->feat & TMU012_FEAT_TOCR) && offset == 0) |
| return s->tocr; |
| |
| cpu_abort (cpu_single_env, "tmu012_write: Bad offset %x\n", |
| (int)offset); |
| return 0; |
| } |
| |
| static void tmu012_write(void *opaque, target_phys_addr_t offset, |
| uint32_t value) |
| { |
| tmu012_state *s = (tmu012_state *)opaque; |
| |
| #ifdef DEBUG_TIMER |
| printf("tmu012_write 0x%lx 0x%08x\n", (unsigned long) offset, value); |
| #endif |
| offset -= s->base; |
| |
| if (offset >= 0x20) { |
| if (!(s->feat & TMU012_FEAT_3CHAN)) |
| cpu_abort (cpu_single_env, "tmu012_write: Bad channel offset %x\n", |
| (int)offset); |
| sh_timer_write(s->timer[2], offset - 0x20, value); |
| return; |
| } |
| |
| if (offset >= 0x14) { |
| sh_timer_write(s->timer[1], offset - 0x14, value); |
| return; |
| } |
| |
| if (offset >= 0x08) { |
| sh_timer_write(s->timer[0], offset - 0x08, value); |
| return; |
| } |
| |
| if (offset == 4) { |
| sh_timer_start_stop(s->timer[0], value & (1 << 0)); |
| sh_timer_start_stop(s->timer[1], value & (1 << 1)); |
| if (s->feat & TMU012_FEAT_3CHAN) |
| sh_timer_start_stop(s->timer[2], value & (1 << 2)); |
| else |
| if (value & (1 << 2)) |
| cpu_abort (cpu_single_env, "tmu012_write: Bad channel\n"); |
| |
| s->tstr = value; |
| return; |
| } |
| |
| if ((s->feat & TMU012_FEAT_TOCR) && offset == 0) { |
| s->tocr = value & (1 << 0); |
| } |
| } |
| |
| static CPUReadMemoryFunc *tmu012_readfn[] = { |
| tmu012_read, |
| tmu012_read, |
| tmu012_read |
| }; |
| |
| static CPUWriteMemoryFunc *tmu012_writefn[] = { |
| tmu012_write, |
| tmu012_write, |
| tmu012_write |
| }; |
| |
| void tmu012_init(uint32_t base, int feat, uint32_t freq) |
| { |
| int iomemtype; |
| tmu012_state *s; |
| int timer_feat = (feat & TMU012_FEAT_EXTCLK) ? TIMER_FEAT_EXTCLK : 0; |
| |
| s = (tmu012_state *)qemu_mallocz(sizeof(tmu012_state)); |
| s->base = base; |
| s->feat = feat; |
| s->timer[0] = sh_timer_init(freq, timer_feat); |
| s->timer[1] = sh_timer_init(freq, timer_feat); |
| if (feat & TMU012_FEAT_3CHAN) |
| s->timer[2] = sh_timer_init(freq, timer_feat | TIMER_FEAT_CAPT); |
| iomemtype = cpu_register_io_memory(0, tmu012_readfn, |
| tmu012_writefn, s); |
| cpu_register_physical_memory(base, 0x00001000, iomemtype); |
| /* ??? Save/restore. */ |
| } |