Sandbox NAND
============

The sandbox NAND controller emulates a NAND controller and attached devices.

Required properties:
- compatible: "sandbox,nand"
- #address-cells: Must be 1
- #size-cells: Must be 0

Any number of child nodes may be present, each representing a NAND device:

Required Properties:
- reg: The chip-select(s) to use. Only single-die devices are supported for now.
- sandbox,id: An array of bytes to be reported by the READID (0x90) command
- sandbox,erasesize: The block size (erase size) of the device, in bytes. Must
                     be a power-of-two multiple of the page size.
- sandbox,oobsize: The size of the OOB area per page, in bytes.
- sandbox,pagesize: The page size (write size) of the device, in bytes. Must be
                    a power of two.
- sandbox,pages: The total number of pages in the device.
- sandbox,err-count: Number of bit errors to inject per step.
- sandbox,err-step-size: Size of the step to use when injecting errors, in
                         bytes. Must evenly divide the page size.

Optional properties:
- sandbox,onfi: The complete ONFI parameter page, including the CRC. Should be
                exactly 256 bytes.
- Any common NAND chip properties as documented by Linux's
  Documentation/devicetree/bindings/mtd/raw-nand-chip.yaml

To match U-Boot's error correction capabilities, errors are only injected into
the data area and the ECC codes. Other data in the OOB area is never corrupted.
Generally, sandbox,err-step-size should be the same as the ECC step size, and
sandbox,err-count should be less than the number of correctable bit errors (the
ECC strength).

Example
-------

nand-controller {
	#address-cells = <1>;
	#size-cells = <0>;
	compatible = "sandbox,nand";

	nand@0 {
		reg = <0>;
		nand-ecc-mode = "soft";
		sandbox,id = [00 e3];
		sandbox,erasesize = <(8 * 1024)>;
		sandbox,oobsize = <16>;
		sandbox,pagesize = <512>;
		sandbox,pages = <0x2000>;
		sandbox,err-count = <1>;
		sandbox,err-step-size = <512>;
	};
};