linux-user: add support for rt_tgsigqueueinfo() system call
Add a new system call: rt_tgsigqueueinfo().
This system call is similar to rt_sigqueueinfo(), but instead of
sending the signal and data to the whole thread group with the ID
equal to the argument tgid, it sends it to a single thread within
that thread group. The ID of the thread is specified by the tid
argument.
The implementation is based on the rt_sigqueueinfo() in linux-user
mode, where the tid is added as the second argument and the
previous second and third argument become arguments three and four,
respectively.
Signed-off-by: Miloš Stojanović <Milos.Stojanovic@rt-rk.com>
Conflicts:
linux-user/syscall.c
Signed-off-by: Riku Voipio <riku.voipio@linaro.org>
diff --git a/linux-user/syscall.c b/linux-user/syscall.c
index 3373853..925ae11 100644
--- a/linux-user/syscall.c
+++ b/linux-user/syscall.c
@@ -238,6 +238,7 @@
#define __NR_sys_getdents64 __NR_getdents64
#define __NR_sys_getpriority __NR_getpriority
#define __NR_sys_rt_sigqueueinfo __NR_rt_sigqueueinfo
+#define __NR_sys_rt_tgsigqueueinfo __NR_rt_tgsigqueueinfo
#define __NR_sys_syslog __NR_syslog
#define __NR_sys_futex __NR_futex
#define __NR_sys_inotify_init __NR_inotify_init
@@ -275,6 +276,8 @@
loff_t *, res, uint, wh);
#endif
_syscall3(int, sys_rt_sigqueueinfo, pid_t, pid, int, sig, siginfo_t *, uinfo)
+_syscall4(int, sys_rt_tgsigqueueinfo, pid_t, pid, pid_t, tid, int, sig,
+ siginfo_t *, uinfo)
_syscall3(int,sys_syslog,int,type,char*,bufp,int,len)
#ifdef __NR_exit_group
_syscall1(int,exit_group,int,error_code)
@@ -8872,6 +8875,19 @@
ret = get_errno(sys_rt_sigqueueinfo(arg1, arg2, &uinfo));
}
break;
+ case TARGET_NR_rt_tgsigqueueinfo:
+ {
+ siginfo_t uinfo;
+
+ p = lock_user(VERIFY_READ, arg4, sizeof(target_siginfo_t), 1);
+ if (!p) {
+ goto efault;
+ }
+ target_to_host_siginfo(&uinfo, p);
+ unlock_user(p, arg4, 0);
+ ret = get_errno(sys_rt_tgsigqueueinfo(arg1, arg2, arg3, &uinfo));
+ }
+ break;
#ifdef TARGET_NR_sigreturn
case TARGET_NR_sigreturn:
if (block_signals()) {
