block/block-backend: add block layer APIs resembling Linux ZonedBlockDevice ioctls
Add zoned device option to host_device BlockDriver. It will be presented only
for zoned host block devices. By adding zone management operations to the
host_block_device BlockDriver, users can use the new block layer APIs
including Report Zone and four zone management operations
(open, close, finish, reset, reset_all).
Qemu-io uses the new APIs to perform zoned storage commands of the device:
zone_report(zrp), zone_open(zo), zone_close(zc), zone_reset(zrs),
zone_finish(zf).
For example, to test zone_report, use following command:
$ ./build/qemu-io --image-opts -n driver=host_device, filename=/dev/nullb0
-c "zrp offset nr_zones"
Signed-off-by: Sam Li <faithilikerun@gmail.com>
Reviewed-by: Hannes Reinecke <hare@suse.de>
Reviewed-by: Stefan Hajnoczi <stefanha@redhat.com>
Reviewed-by: Dmitry Fomichev <dmitry.fomichev@wdc.com>
Acked-by: Kevin Wolf <kwolf@redhat.com>
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
Message-id: 20230508045533.175575-4-faithilikerun@gmail.com
Message-id: 20230324090605.28361-4-faithilikerun@gmail.com
[Adjust commit message prefix as suggested by Philippe Mathieu-Daudé
<philmd@linaro.org> and remove spurious ret = -errno in
raw_co_zone_mgmt().
--Stefan]
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
diff --git a/meson.build b/meson.build
index d3cf489..25a4b9f 100644
--- a/meson.build
+++ b/meson.build
@@ -2025,6 +2025,8 @@
endif
# has_header_symbol
+config_host_data.set('CONFIG_BLKZONED',
+ cc.has_header_symbol('linux/blkzoned.h', 'BLKOPENZONE'))
config_host_data.set('CONFIG_EPOLL_CREATE1',
cc.has_header_symbol('sys/epoll.h', 'epoll_create1'))
config_host_data.set('CONFIG_FALLOCATE_PUNCH_HOLE',
@@ -2060,6 +2062,9 @@
config_host_data.set('HAVE_STRUCT_STAT_ST_ATIM',
cc.has_member('struct stat', 'st_atim',
prefix: '#include <sys/stat.h>'))
+config_host_data.set('HAVE_BLK_ZONE_REP_CAPACITY',
+ cc.has_member('struct blk_zone', 'capacity',
+ prefix: '#include <linux/blkzoned.h>'))
# has_type
config_host_data.set('CONFIG_IOVEC',
