scsi: Use device_cold_reset() and bus_cold_reset()
In the SCSI subsystem we currently use the legacy functions
qdev_reset_all() and qbus_reset_all(). These perform a recursive
reset, starting from either a qbus or a qdev. However they do not
permit any of the devices in the tree to use three-phase reset,
because device reset goes through the device_legacy_reset() function
that only calls the single DeviceClass::reset method.
Switch to using the device_cold_reset() and bus_cold_reset()
functions. These also perform a recursive reset, where first the
children are reset and then finally the parent, but they use the new
(...in 2020...) Resettable mechanism, which supports both the old
style single-reset method and also the new 3-phase reset handling.
Since no devices attached to SCSI buses currently try to use 3-phase
reset, this should be a no-behaviour-change commit which just reduces
the use of a deprecated API.
Commit created with:
sed -i -e 's/qdev_reset_all/device_cold_reset/g;s/qbus_reset_all/bus_cold_reset/g' hw/scsi/*.c
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-Id: <20221013160623.1296109-2-peter.maydell@linaro.org>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/hw/scsi/megasas.c b/hw/scsi/megasas.c
index 7082456..9cbbb16 100644
--- a/hw/scsi/megasas.c
+++ b/hw/scsi/megasas.c
@@ -1484,7 +1484,7 @@
MegasasCmd *tmp_cmd = &s->frames[i];
if (tmp_cmd->req && tmp_cmd->req->dev->id == target_id) {
SCSIDevice *d = tmp_cmd->req->dev;
- qdev_reset_all(&d->qdev);
+ device_cold_reset(&d->qdev);
}
}
return MFI_STAT_OK;
