migrate_start_postcopy: Command to trigger transition to postcopy
Once postcopy is enabled (with migrate_set_capability), the migration
will still start on precopy mode. To cause a transition into postcopy
the:
migrate_start_postcopy
command must be issued. Postcopy will start sometime after this
(when it's next checked in the migration loop).
Issuing the command before migration has started will error,
and issuing after it has finished is ignored.
Signed-off-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
Reviewed-by: Eric Blake <eblake@redhat.com>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Reviewed-by: Amit Shah <amit.shah@redhat.com>
Signed-off-by: Juan Quintela <quintela@redhat.com>
diff --git a/migration/migration.c b/migration/migration.c
index bb4c92e..9c46472 100644
--- a/migration/migration.c
+++ b/migration/migration.c
@@ -668,6 +668,28 @@
}
}
+void qmp_migrate_start_postcopy(Error **errp)
+{
+ MigrationState *s = migrate_get_current();
+
+ if (!migrate_postcopy_ram()) {
+ error_setg(errp, "Enable postcopy with migration_set_capability before"
+ " the start of migration");
+ return;
+ }
+
+ if (s->state == MIGRATION_STATUS_NONE) {
+ error_setg(errp, "Postcopy must be started after migration has been"
+ " started");
+ return;
+ }
+ /*
+ * we don't error if migration has finished since that would be racy
+ * with issuing this command.
+ */
+ atomic_set(&s->start_postcopy, true);
+}
+
/* shared migration helpers */
static void migrate_set_state(MigrationState *s, int old_state, int new_state)
