hw/intc/arm_gicv3: Use correct number of priority bits for the CPU
Make the GICv3 set its number of bits of physical priority from the
implementation-specific value provided in the CPU state struct, in
the same way we already do for virtual priority bits. Because this
would be a migration compatibility break, we provide a property
force-8-bit-prio which is enabled for 7.0 and earlier versioned board
models to retain the legacy "always use 8 bits" behaviour.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20220512151457.3899052-6-peter.maydell@linaro.org
Message-id: 20220506162129.2896966-5-peter.maydell@linaro.org
diff --git a/target/arm/cpu.h b/target/arm/cpu.h
index a99b430..a42464e 100644
--- a/target/arm/cpu.h
+++ b/target/arm/cpu.h
@@ -1002,6 +1002,7 @@
int gic_num_lrs; /* number of list registers */
int gic_vpribits; /* number of virtual priority bits */
int gic_vprebits; /* number of virtual preemption bits */
+ int gic_pribits; /* number of physical priority bits */
/* Whether the cfgend input is high (i.e. this CPU should reset into
* big-endian mode). This setting isn't used directly: instead it modifies
