blockdev: reset werror/rerror on drive_del
Paolo Bonzini <pbonzini@redhat.com> suggested the following test case:
1. Launch a guest and wait at the GRUB boot menu:
qemu-system-x86_64 -enable-kvm -m 1024 \
-drive if=none,cache=none,file=test.img,id=foo,werror=stop,rerror=stop
-device virtio-blk-pci,drive=foo,id=virtio0,addr=4
2. Hot unplug the device:
(qemu) drive_del foo
3. Select the first boot menu entry
Without this patch the guest pauses due to ENOMEDIUM. The guest is
stuck in a continuous pause loop since the I/O request is retried and
fails immediately again when the guest is resumed.
With this patch the error is reported to the guest.
Note that this scenario actually happens sometimes during libvirt disk
hot unplug, where device_del is followed by drive_del. I/O may still be
submitted to the drive after drive_del if the guest does not process the
PCI hot unplug notification.
Reported-by: Dafna Ron <dron@redhat.com>
Signed-off-by: Stefan Hajnoczi <stefanha@redhat.com>
Reviewed-by: Kevin Wolf <kwolf@redhat.com>
diff --git a/hmp-commands.hx b/hmp-commands.hx
index 9cea415..4f5a3fd 100644
--- a/hmp-commands.hx
+++ b/hmp-commands.hx
@@ -185,6 +185,8 @@
submitted against the host device underlying the disk. Once a drive has
been deleted, the QEMU Block layer returns -EIO which results in IO
errors in the guest for applications that are reading/writing to the device.
+These errors are always reported to the guest, regardless of the drive's error
+actions (drive options rerror, werror).
ETEXI
{
