qemu /
ipxe /
165995b7e917a94533799fe43d14f5e3b1fef285 [efi] Restructure handling of autoexec.ipxe script
We currently attempt to obtain the autoexec.ipxe script via early use
of the EFI_SIMPLE_FILE_SYSTEM_PROTOCOL or EFI_PXE_BASE_CODE_PROTOCOL
interfaces to obtain an opaque block of memory, which is then
registered as an image at an appropriate point during our startup
sequence. The early use of these existent interfaces allows us to
obtain the script even if our subsequent actions (e.g. disconnecting
drivers in order to connect up our own) may cause the script to become
inaccessible.
This mirrors the approach used under BIOS, where the autoexec.ipxe
script is provided by the prefix (e.g. as an initrd image when using
the .lkrn build of iPXE) and so must be copied into a normally
allocated image from wherever it happens to previously exist in
memory.
We do not currently have support for downloading an autoexec.ipxe
script if we were ourselves downloaded via UEFI HTTP boot.
There is an EFI_HTTP_PROTOCOL defined within the UEFI specification,
but it is so poorly designed as to be unusable for the simple purpose
of downloading an additional file from the same directory. It
provides almost nothing more than a very slim wrapper around
EFI_TCP4_PROTOCOL (or EFI_TCP6_PROTOCOL). It will not handle
redirection, content encoding, retries, or even fundamentals such as
the Content-Length header, leaving all of this up to the caller.
The UEFI HTTP Boot driver will install an EFI_LOAD_FILE_PROTOCOL
instance on the loaded image's device handle. This looks promising at
first since it provides the LoadFile() API call which is specified to
accept an arbitrary filename parameter. However, experimentation (and
inspection of the code in EDK2) reveals a multitude of problems that
prevent this from being usable. Calling LoadFile() will idiotically
restart the entire DHCP process (and potentially pop up a UI requiring
input from the user for e.g. a wireless network password). The
filename provided to LoadFile() will be ignored. Any downloaded file
will be rejected unless it happens to match one of the limited set of
types expected by the UEFI HTTP Boot driver. The list of design
failures and conceptual mismatches is fairly impressive.
Choose to bypass every possible aspect of UEFI HTTP support, and
instead use our own HTTP client and network stack to download the
autoexec.ipxe script over a temporary MNP network device. Since this
approach works for TFTP as well as HTTP, drop the direct use of
EFI_PXE_BASE_CODE_PROTOCOL. For consistency and simplicity, also drop
the direct use of EFI_SIMPLE_FILE_SYSTEM_PROTOCOL and rely upon our
existing support to access local files via "file:" URIs.
This approach results in console output during the "iPXE initialising
devices...ok" message that appears while startup is in progress.
Remove the trailing "ok" so that this intermediate output appears at a
sensible location on the screen. The welcome banner that will be
printed immediately afterwards provides an indication that startup has
completed successfully even absent the explicit "ok".
Signed-off-by: Michael Brown <mcb30@ipxe.org>
4 files changed
